Part Number: SN65DSI84 Hi,
i have a PCB where a imx8mm is connected over mipi_disi with the SN65DIS84ZHR. On the LVDS there is a Panel connected from LG LM215WF3. This panel has a resolution of 1920x1080. I have configured in the dts the panel and lvds…
Part Number: SN65DSI83 Other Parts Discussed in Thread: SN65DSI84 , hello expert:
now my board used the SN65DSI84 , as we know the SN65DSI83 is compatible with DSi84 at hardware , i want to know is there any difference at the register configuration…
Part Number: SN65DSI84-Q1 Hi,
As part of hardware evaluation, I would like to evaluate the waveform of the IRQ pin of SN65DSI84TPAPRQ1.
Looking at the causes of IRQ, I think it is difficult to cause it intentionally, but please let me know if there…
Part Number: SN65DSI84 Dear Team,
Our customer are using the SN65DSI84 LVDS bridge for our LCM project.
LCM might show black screen while turning on or off screen.
Action of turning on or off screen is including turn on DSI relative from SOC and…
Part Number: SN65DSI84 Other Parts Discussed in Thread: SN65DSI85 Hi.
I wish to hook up an NXP RT1170 (2 channel MIPI DSI output) to a high def display with a dual channel (odd/even) LVDS input port.
Can you please confirm the SN65DSI84 can handle…
Part Number: SN65DSI84 Hello Zach,
I'm sorry for this 3rd post but we still have the flickering issue.
Below:
#Our design's state:
1. We took the LCD parameters
2. We configured the MIPI-DSI / LVDS bridge registers
3. We configured…
Part Number: SN65DSI84 Dear Expert
Now we have two problems with SN65DSI84, as follows:
1. After we configure the SN65DSI84 register, the LCD screen shows, but the check value of E5 register is not 00, but 81. Could you help explain what 81 stands…
Part Number: SN65DSI84-Q1 Tool/software: Hi,
Since the data sheet says "LVDS CLK A to CLK B skew 10ps," I understand that the equal delay condition for CLK A and CLK B is 10 ps. Also, since it says "Keep lengths to within 5 mils of each other" between…
Part Number: SN65DSI84 Hello：
Does sn65dsi84 have ESD check mechanism? Now the board contacts + / - 6kV, the screen will be black, but the backlight is good, and then I turn off the screen and light it up again, it can be displayed normally. Does it…
