Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.
Part Number: SN65HVD235 I have a a device(s) in which a serial port data is transmitted via CAN transceivers (not my design) to another device with same arrangement. Only these two devices are ever connected to this communication line.
The transceiver…
Part Number: SN65HVD235 I am attempting to locate a drop in replacement for the TCAN332D that offers higher bus fault voltage tolerance.
The SN65HVD235 appears to be a possibility with one possible problem. The RS pin appears to need a ground, pull up…
Part Number: SN65HVD235 Hello team,
My customer has been using SN65HVD235 CAN driver in their design for years. They have not had ESD issues in the past, however now they’re getting some hard and soft failures. Some times it fails and burns out the CPU…
Part Number: SN65HVD235 Hi,
Is there any CAN Transceiver with Autobaud feature similar to SN65HVD235 to comply against J1939-16 standard operating at 5 volt .
Regards
Dilip
Part Number: SN65HVD235 Other Parts Discussed in Thread: SN65HVD1050 Hi team,
Customer will use both 3.3V CAN (SN65HVD235) and 5V CAN (SN65HVD1050) in the same CAN bus.
- Could both 3.3V CAN and 5.0V CAN use in the same CAN bus ?
- If yes, are there…
Part Number: SN65HVD235 Other Parts Discussed in Thread: TCAN4550 Hi sir,
I did not find a can controller in our Ti web. pls provide a PN for me, and the interface support uart.
Thanks a lot.
Part Number: SN65HVD235 I didnt understand very well those statements:
"After transmission of an error frame, an error passive node must wait for 6 consecutive recessive bits on the bus before attempting to rejoin bus communications" (Microchip)
"Therefore…
Part Number: SN65HVD235
I'm a beginner on interfaces and networks. I have some questions about CAN synchronization and bit sampling.
To do the Resynchronization, I understand that the nodes need to get the bus state outside the sampling point, to…
Hi Eric:
Also the reading for 8V and 12V were different than the ones provided since they seem like the device was working normal, in our reproduce test they were still following the input voltage as expected not like images provided.
We suspect a setup…
