Part Number: SN65HVD24 Tool/software: Hi Team,
My customer want to add a diode DX1 between 5V power and pull up resistor in A line as below picture to avoid the impact of noise from power.
Does it bring any bad influence?
BR,
Moon
Part Number: SN65HVD24 We are trying to use the SN65HVD24D in our application (in place for example of Exar XR33055 or Maxim MAX33071EASA+) but it fails due to UART errors. The speed is only 1Mbps, and the bus does have external biasing. I suspect the…
Part Number: SN65HVD24 Other Parts Discussed in Thread: THVD1410 , THVD2450 , , THVD1450 Hi Sir,
For shortage issue for SN65HVD24DR, my customer is looking for the alternate device and the bit rates need to achieve 10~15Mbps with 300m cable length.
Could…
Hi Schott-san
I apologize for late response.
I was waiting for a response from my customer. They adjusted the failsafe bias resistor to eliminate the problem. However, they sent the waveform data because they were not sure if they were concerned about this…
Part Number: SN65HVD24 Other Parts Discussed in Thread: STRIKE Hi team,
this is brandon. in our before design, SN65HVD24 is linked directly on BUS, which cause the demage when Lighting happened. therefore, we intended to design the Lightning protection…
Part Number: SN65HVD24 Dear Specialists, Customers need FMEA information to adopt new parts. Please tell me the FMEA information of SN65HVD24. It helps in design-in.
Best regards, Yusuke
Part Number: SN65HVD24 Hi, The following contents are described in the SN65HVD24 data sheet. My customer wants to implement the above circuit using SN65HVD24. Could you tell me the recommended SN65HVD24 circuit that supports SUPER-485? And Please tell me…
Part Number: SN65HVD24 Hi
Used SN65HVD24, failing transmission of 300 meter cable at 4MHz rates.
At this point, a surge absorption part is used for requirement of IEC61000-4-5.
If absorption part is removed, transmission can be passed above use case…
