Part Number: SN65LVDS050 Other Parts Discussed in Thread: SN65MLVD040 We are currently using LVDS to connect two devices. It is a point-to-point communication system. In addition, we are planning to develop a new system. We are planning to use MLVDS in…
Part Number: SN65LVDS050 There wasn't any information on the datasheet with regards to unused I/Os for the driver AND receiver.
Do I need to tie them to VCC or GND directly or through a resistor? Or do I need to leave them hanging?
Other Parts Discussed in Thread: SN65LVDS31 , SN65LVDS33 , SN65LVDS179-EP , SN65LVDS051-Q1 , SN65LVDS050-Q1 I am looking for an EP (or SEP) LVDS driver & receiver combination for use with the SpaceWire protocol, which needs 2 x 400Mbps driver and 2 x…
Part Number: SN65LVDS050 I am looking for Theta_JC values for the following four components: SN65LVDS050PW, SN65HVD379DR, SN65LVDS34D, DS26LV32ATMX. They are not located on the component datasheets like most TI components.
Hello,
No. The 400Mbps is mentioned in both datasheets (SN65LVDS050 & SN65LVDS050-Q1) and it is under ideal conditions at room temp, short distance, only one channel is active, etc. The table in the SN65LVDS050 datasheet is conservative and uses max…
Other Parts Discussed in Thread: MLVD20XEVM , SN65MLVD201 , THVD1450 , SN65LVDS050 Hi TI,
Newer engineer here, I have a 1PPS signal that will be provided via LVDS signal standard but is required to be sent to the receiver as a RS-422 compliant signal…
Part Number: DS90LV032A Other Parts Discussed in Thread: DS90LV001 , SN65LVDS32 , SN65LVDS050 , SN65LVDS33 , SN65LVDS349 , DS90LV012A , SN65MLVD048
ATIA/EIA-644-A standard allows multiple receiver operation and I used DS90LV032A and MAX9180 receivers…
Hi!
I am looking for a -55 to +125 degC LVDS transceiver. The SN65LVDS180-ep, SN65LVDS050-ep and SN65LVDS051-ep looks interesting.
I wonder if these are ITAR regulated?
I wonder if you can tell on a general basis whether the different ratings (enhanced…
