Part Number: SN65LVDS125A Hi Guys,
There is a project which need SGMII interfaces crosspoint before PHY,so I found SN65LVDS125A at TI website;However,I'm not very sure whether SN65LVDS125A is suitable or not;Pls help me to confirm this problem,Thans…
Part Number: SN65LVDS125A dear TI buddy
my customer used SN65LVDS125A to design a lvds project, but the output waveform is not symmetrical,besides,the output amplitude(Vpn) is only 100mv when i connect the LCD panel,if disconnect the LCD,the output…
Hi Hiro,
If the input is unused, it is okay to use without external resistor. Since the input is not used, we recommend that you disable the unused input by pulling DE for that input high. Disabling the channel will prevent the outputs from toggling…
Part Number: SN65LVDS125A I have a system with two ASICs communicating one-way (simplex) using 400 MHz LVDs signalling. I need to test what happens to the receiver ASIC when the LVDS signals are interrupted (the three test cases are disconnected, shorted…
Part Number: SN65LVDT125A Other Parts Discussed in Thread: SN65LVDS125A Hello Team, We are planning to use the IC SN65LVDT125A in one of our products. The use case seems little differnt from the intended application of the IC.
We have an MCU which acts…
Hi Carsten,
The SN65LVCP408 does not support LVDS outputs. The SN65LVDS250 and SN65LVDS125A support LVDS though but they will not provide you with an 8:1 mux.
Regards,
Mike
Other Parts Discussed in Thread: SN65LVDS125A , SN65LVDS250 , DS90LV110T Hi
I have a customer enquiry, requirement as
One TX and 4 RX. Simplex, at 1Gbps. prefers a pair of differential line between TX and RX.
The TX FPGA is going to output LVDS…
