Part Number: SN65LVDS31-EP Is it necessary to have an output series resistor on the LVDS outputs when driving a 100ohm differential load?
Output load is shown to be 5 ohms so a 45-ohm series resistor should help with reflections?
- Michael
Part Number: SN65LVDS31-EP Hello,
For the SN65LVDS31MDREP I had two questions:
Based on other TI data sheets, is it safe to assume theta-JC in this data sheet means top-case?
Is there unpublished theta-JB? Or just theta-JA and theta-JC?
Part Number: SN65LVDS31-EP Hello E2E Experts,
Good day.
I found SN65LVDS31-EP which covers the temperature range (-55'C to 125'C) and works with 3.3V nominal.
Do you see any reason for the incompatibility between this and my original AM26LV31ID…
Part Number: SN65LVDS31-EP Other Parts Discussed in Thread: SN65LVDS31
Hi Team,
Good day. Our customer is using the SN65LVDS31MDREP to translate a 3.3V Clock signal to LVDS.
For this project, they need to compute the jitter added by each device. The jitter…
Part Number: SN65LVDS31-EP Hi Support,
The data sheet did not include HBM/CDM.
Please tell me the test results of ESD.
-Part#:
SN65LVDS31MDREP
SN65LVDS33MDREP
-HBM: ? V
-CDM: ? V
Best Regards;
Hideyuki
Part Number: SN65LVDS31-EP Hi Team, In one of our customer's application they need to provide information concerning the fault tolerance of SN65LVDS31-EP. In cases of failure of the LVDS receiver (end-device), 3.6V will be directly applied to the differential…
Hello,
Unfortunately, we do not have data on this device as it relates to additive jitter. However, from the results in the application note post above, it would be reasonable to infer that the additive jitter would be on the order of a few hundred pico…
Part Number: SN65LVDS31-EP Other Parts Discussed in Thread: SN65LVDS31 , SN65LVDS33-EP , Hello,
I am using a SN65LVDS31 on my design and I would like to know what is the maximum voltage tolerate by the differential output without degradation ? The synoptic…
Part Number: SN65LVDS31-EP Other Parts Discussed in Thread: SN65LVDS31 Hi team,
Good day. Our customer is requesting for the ESD HBM rating for V62/07627-01XE. Is the ESD HBM rating of non-EP version which is SN65LVDS31 applicable?
Regards, Carlo
Part Number: SN65LVDS31-EP Other Parts Discussed in Thread: SN65LVDS33-EP Hello,
Can you tell me if the SN65LVDS31-EP and SN65LVDS33-EP are BiCMOS or CMOS device?
I am considering using them in a CubeSat and radiation effects depends on the technology…
