Part Number: SN65LVDS9638 Can you please provide the junction to case thermal resistance, the absolute maximum junction temperature, and the operating junction temperature range for part number SN65LVDS9638D?
Part Number: SN65LVDS9638 Dear all,
we used the SN65LVDS9638DR LVDS Receiver in one of our designs. We only needed a single channel. We couldn't find any information about how to handle unused channels.
Therefore the input pin 2A is NC (open), the…
Part Number: SN65LVDS9638 Hi guys, see in the datasheet of this product SN65LVDS9638 different ending of the part like SN65LVDS9638DGK and SN65LVDS9638DGKG4. I search everywhere to find the meaning of the "G4" at the end and didn't find anything.…
Part Number: SN65LVDS9638 Hi Team, Requesting for our customer. May we ask for the junction-to-ambient and junction-to-case (bottom) for SN65LVDS9638 (DGN package)? Thanks in advance! Kind Regards, Jejomar
Part Number: SN65LVDS9638 Hello,
today I searched for an error in my LVDS transceivers. In the end it was a SN65LVDS9638 where in one driver circuit the negative output was GND and the positive was without any offset. It seems the common mode voltage…
Part Number: DS90LVRA2 Other Parts Discussed in Thread: SN65LVDS9638 , source is 3.3V single-ended, while target is 1.8V single-ended.
One solution to use LVDS is to shift down after LVDS receiver like in: www.ti.com/.../snla307
Would it be possible to…
Part Number: SN65LVDS9638 Other Parts Discussed in Thread: UA9638C-EP , THVD1450 , AM26LV31E Is there an RS422 drop in replacement for this driver (that will operate over temperature)?
Part Number: SN65LVDS9638 Hello,
I could not directly find the information which the powerPad needs to be connected to - the GND or power plane for this specific device. Could you please advise?
Regards,
Ramon
Hi Tao,
Sorry for the long delay.
Both values are valid. There is a typical relationship between signaling rate and distance achievable depending on the quality of the eye pattern at the receiver that is either desired or needed. Please refer section…
Part Number: SN65LVDS9638 Team,
are there solutions for TTL-to-LVDS drivers that support adjustable slope rates for the LDVS output edges, such as through an external resistor?
Thanks and best regards