• SN65MLVD201: Theta JC

  

  Brad Henson

  TI Thinks Resolved

  Part Number: SN65MLVD201 Hello, please provide the theta-jc value for SN65MLVD201DR. Thank you - Brad

  • 4 months ago
  • Interface
  • Interface forum

• SN65MLVD201: SN65MLVD201DG4

  

  Aaron Skousen

  Part Number: SN65MLVD201 What is the junction limit for SN65MLVD201DG4? The only information in the datasheet is that the operating temperature is 85°C and the max storage temperature is 150°C.

  • over 3 years ago
  • Interface
  • Interface forum
Answered

• SN65MLVD201: SN65MLVD201, the receiver idle output voltage goes VCC/2

  

  Alex Red

  Resolved

  Part Number: SN65MLVD201 Hello, I am testing a device which is using an M-LVDS driver to replace an RS485 driver to achieve better performances... the driver is the SN65MLVD201, and I have a trasmitter sending data by UART through the driver on the…

  • Resolved

  • over 4 years ago
  • Interface
  • Interface forum
Answered

• SN65MLVD201: SN65MLVD201DR Data rate vs cable length. 100Mbps@100Ft.

  

  ElecFun

  Resolved

  Part Number: SN65MLVD201 Hi, We are planning to use SN65MLVD201DR based half duplex link between two boards using 100ft of shielded cat5e cable, and wondering if even possible to achieve 100Mbps of data rate using 8b/10b encoding scheme. I found signaling…

  • Resolved

  • over 3 years ago
  • Interface
  • Interface forum

• SN65MLVD201: For M-LVDS Failsafe Biasing Application

  

  ArTzy

  TI Thinks Resolved

  Part Number: SN65MLVD201 Hi Expert, Using MLVDS - SN65MLVD201D, we have question about this part regarding the Failsafe biasing of MLVDS. We want to ensure that customer are following the information in the data sheet to choose the resistors. R3 …

  • over 3 years ago
  • Interface
  • Interface forum

• Regarding the serious problem of signal quality reflection at intermediate nodes when multiple SN65MLVD201 devices are connected to the bus

  

  Beryl Wang

  TI Thinks Resolved

  Other Parts Discussed in Thread: SN65MLVD201 , DS90LV001 , DS10BR150 Hi, My design is to have a bus backplane with 10 cards inserted on it. Each card has a bus interface chip SN65MLVD201 device, and there are 100R termination resistors at both ends…

  • over 2 years ago
  • Interface
  • Interface forum

• SN65MLVD201: Microcontroller suitable for serializing/de-serializing data at max speed of 100Mbps/50MHz

  

  ElecFun

  TI Thinks Resolved

  Part Number: SN65MLVD201 Hello, We are using SN65MLVD201DR, half-duplex MLVDS transceiver between two units for serializing and de-serializing data. Max operating data rates is 100Mbps with 8b/10b NRZ and so highest frequency component is 50Mhz. Is…

  • over 3 years ago
  • Interface
  • Interface forum

• SN65MLVD201: differential IO impedance

  

  Michael T Schneider

  TI Thinks Resolved

  Part Number: SN65MLVD201 I’m looking for some additional information on one of your M-LVDS drivers (SN65MLVD201). I’m specifically trying to determine if the differential IO (A and B) remain high-impedance (can tolerate the line being externally driven…

  • over 5 years ago
  • Interface
  • Interface forum

• SN65MLVD201: I am looking for the thermal metrics for the SN65MLVD201 component

  

  Sam Shoemaker

  TI Thinks Resolved

  Part Number: SN65MLVD201 Hi, I am looking for the following thermal information for the SN65MLVD201 Component. Thermal resistance from junction to case top - Theta JC Thermal resistance from junction to case bottom - Theta JC Thermal resistance…

  • over 7 years ago
  • Interface
  • Interface forum

• SN65MLVD201: About the use of differential transceivers

  

  Annie Liu

  TI Thinks Resolved

  Part Number: SN65MLVD201 Other Parts Discussed in Thread: P82B96 Hi Team, A customer's project needs a two-way io board to board transmission, about 1M speed. Customer would like to know can the differential drive be used like this? Thanks, A…

  • over 6 years ago
  • Interface
  • Interface forum

Didn't find what you are looking for? Post a new question.