Part Number: SN74AHC1G09 Tool/software: Hi
Greetings,
This is Kumar, Barnikana representing Philips team.
I have requested in Mail to the TI Team, but didn't recieved any response.
Please provide the following technical information for our ongoing…
Part Number: SN74AHC1G09 Tool/software: Hi Team,
1. for inputs , What is the VIH and VIL levels when VDD=3.3V , 1.8V and 5V??
2. for output open drain, VOH and VOL to be considered 0V to Vpullup (pull up voltage)?
3. Can open drain output pull…
Part Number: SN74AHC1G09 Hello,
We are trying to use SN74AHC1G09 open drain AND gate in our design.
The Output of the device is NOT stable. It is Fluctuating and dropping down to 1V even though the Inputs are at High state.
The device operating…
Part Number: SN74AHC1G09
Question 1 :
The Absolute Maximum Ratings shows Vo=Vcc+0.7V (Max)
It's means 7V+0.7V? or Vcc is typical use Vcc? (ex If use Vcc=3.3V, Vo=3.3+0.7?)
Question 2 :
The Recommended Operating Conditions shows Vo=5.5V (Max…
Part Number: SN74AHC1G09 Hello,
my customer would need to know the FIT rates and pin FMA of the component SN74AHC1G09DCKR.
It is used in an ebike Battery Management system.
Can you provide this information?
They are considering ISO13849 to…
Part Number: SN74AHC1G09 Hi team,
Our customer has question about the Δt/Δv of SN74AHC1G09.
What will happen if the rising or falling edge of the input signal is lower than the value in the table below? Will it be output jitter? How to avoid it in…
Part Number: SN74AHC1G09 Hi Team, May I ask for help? My customer have a concern as stated below:
"For SN74AHC1G09DCKR can you please provide theta JB or JC to bottom of case and maximum operational junction temperature. Datasheet only provides Tambient…
Part Number: SN74AHC1G09 Hi Team, We're aware that the max junction temperature for standard logic devices are the same as their max storage temperature, which is typically 150C as discussed on the FAQ: https://e2e.ti.com/support/logic-group/logic/f/logic…
