Part Number: SN74AHC541-Q1 Dear TI Team,
I would like to request the pin Failure mode analysis data(FMA) for the SN74AHC541-Q1 device for compliance and documentation purposes. Kindly share the latest available FMA & FMD data.
Thank you for your support…
Part Number: SN74AHC541-Q1 Tool/software: Dear TI Team,
I would like to request the pin Failure mode analysis data(FMA) for the SN74AHC541-Q1 device for compliance and documentation purposes. Kindly share the latest available FMA & FMD data.
Thank…
Part Number: SN74AHC541-Q1 Hi team,
Customer wants to know that at OE0 OE1 low condition (device enabled with VCC supplied), when output pin exceed abs voltage (for example Y1 short to external 12V) and damage, will there be internal leakage to A1 pin…
Part Number: SN74AHC541 Tool/software: HI, Staff
The CDM ESD Ratings for SN74AHC541 (SCLS261Q= Rev.Q) is 1000V lower than the Rev.P specifications. The Rev.P datasheet said +2000V.
Q1. What is the reason for the CDM value dropping by 1000V? Q2. Does…
Part Number: SN74AHC541-Q1 Tool/software: Hi team,
My Customer need FIT/ FMD information to conducting FMEDA, but I don't find the document on TI.com, so I understand these device is not "FUSA capable".
So how to conduct FMEDA? My customer need…
Part Number: SN74AHC541 Other Parts Discussed in Thread: SN74HC125 Tool/software: i try to simulate pspice model of SN74AHC541PW, but im getting always zero output without getting any error, can you please check that model is working or not.
Part Number: SN74AHC541 In our design, we have a single 1PPS signal, and our objective is to use SN74AHC541 buffer to obtain four 1PPS outputs. Jitter and skew are critical parameters for our application, but unfortunately, we could not find specific…
Part Number: SN74AHC541-Q1 Hi Expert,
One use-case would like to check with you. In below diagram, when SN74AHC541-Q1 is 5V powered, if there have a 5V high level signal on the output side(Yx), does this 5V signal will have impact for the device no…
Part Number: SN74AHC541-Q1
Hi team,
Why is the datasheet marked 'TI Confidential' ?
I would like to suggest a replacement for '74VHC541FT (BJ)'.
Requirements: AEC-Q100 qualified, TSSOP package
Please tell me what products you recommend.…
Part Number: SN74AHC541 Hi All,
May we know what is the expected fan-out for SN74AHC541?
I confirmed the following comments on E2E.
( e2e.ti.com/.../3233187
" All CMOS families have a fan-out of 1000 or so, due to the high input impedance. In…
