Part Number: SN74AUP1G17 Currently we are using this buffer SN74AUP1G17DBVR in our design, it supports input supply Voltage range from 0.8V to 3.6V.
We need a buffer part which is capable of supplying 0.75V , any voltage range which can give this supply…
Part Number: SN74AUP1G17 Dear TI,
I have a question about maximal temperature of Schmitt trigger SN74AUP1G17.
Its maximal junction temperature is 150 °C and maximal operating free-air temperature is 85 °C.
Electrical characteristics (like thresholds…
Part Number: SN74AUP1G17 Measuring SN74AUP1G17 Low-Power Single Schmitt-Trigger Buffer Delta Icc with 3.3V supply and 2V input results in >150uA of current.
Datasheet says 40uA max Delta Icc at room temp.
Device is mounted to a breakout board. Current…
Part Number: SN74AUP1G17 Other Parts Discussed in Thread: SN74AUP2G79 , SN74AUP1G04 , SN74AUP1G74 , SN74AUP1G58 Hello
My customer would like to know dynamic-power data of the below part numbers (ideally 3V VCC and about 2KHz signal).
SN74AUP1G17
SN74A…
Part Number: SN74AUP1G17 The recommended voltage range of the power supply is 0.8~3.6V, but is there any provision for the current value required to drive the IC?
The maximum Icc is 0.9uA, but does that mean that a minimum current of 0.9uA is required…
Part Number: SN74AUP1G17 Other Parts Discussed in Thread: SN74AUP1G14 , , TINA-TI Hi.
I am currently using the SN74AUP1G14 and SN74AUP1G17 Pspice models in TINA sumulations an mentioned in the attached schematic.
When, as shown in the schematic, these logic…
Part Number: SN74LVC1G125 Other Parts Discussed in Thread: SN74AUP1G17 , SN74LVC1G17 , LM321LV Hi Sir,
I need a buffer/ driver to control my RF device but it need the isolation spec. at 2.4GHz~7.2GHz.
The input is CMOS/3.3V.
The drive capacity need 1.5mA…
Part Number: SN74AUP1G17 Other Parts Discussed in Thread: SN74AUC1G17 Hi Team,
I use SN74AUP1G17 to re-drive a clock source, 1,25V 38.5MHz, its rise time is under 2ns. However, the output of SN74AUP1G17 is not fast enough, its rise time is around 6-8ns…