Part Number: SN74AUP1G99 Tool/software: I am reaching out on behalf of my employer to request a letter of volatility (LOV) for part SN74AUP1G99. The LOV will be used to develop sanitization procedures for hardware which this part is installed on. Could…
Part Number: SN74AUP1G99 Hi, I have a question about SN74AUP1G99 input High threshold. The chip in our application is supplied by 3.3V voltage, and the input A/B/C/D are connected to 2.5V through a 5K pull-up resistor. Will SN74AUP1G99 treat 2.5V as logic…
Part Number: SN74LVC1G99-Q1 Other Parts Discussed in Thread: SN74AUP1G99 We have found that strong under/overshoots and ringing occur on a clock signal due to the lack of an electrical termination (series resistor). I could not find, but I wonder if there…
Reposting the list of devices with GPNs as the answers wont change between package types or quantity
SN74AC74 SN74AHC1G32 SN74AUP1G99 SN74LVC04A SN74LVC04APWTE4
SN74LVC125A
SN74LVC126A
SN74LVC1G07
SN74LVC1G08
SN74LVC1G14
SN74LVC1G97
SN74LVC1G99…
Part Number: SN74AHC02 Other Parts Discussed in Thread: SN74LVC1G99 , SN74AUP1G99 , SN74AHC125 Hi, Team
my customer prefer to find a Nor gates with Enable pin.
when disable the EN pin, the output have high impedance.
do we have such 3 channel Nor…
The SN74AUP1G99 has an active-low OE pin, and the output voltage must not be above V CC .
Alternatively, keep the '07 and combine the two input signals with a SN74AUP1G97.
Any buffer with an O̅E̅ pin can be made to have an open-drain output by using O̅E̅ for the input signal. (xx125 buffers are available in many families.)
But the only devices with both O̅E̅ and Schmitt-trigger inputs are SN74LVC1G99 and SN74AUP1G99.…
Hi Sanjeev,
I would highly recommend using the encrypted model along with pspice (there is a free trial for the software) as the model is exceedingly accurate compared to the model I sent for TINA-TI.
That said: the simulations do look correct. The…
If you connect the same signal to both inputs of an XNOR gate, the output is constant low. (To get the NOT function, tie one input of the XNOR gate to GND, or use a NOR gate.)
In general, there is no electrical problem when you connect the same signal…
