Part Number: SN74AVC2T45 I am using the SN74AVC2T45 to provide electrical isolation between GPIOs that connect from a CPU to an STM32. The below photo shows my setup In this setup, 3V3_STM is enabled first, and then after a button press 3V3_RUN gets enabled…
Part Number: SN74AVC2T45
Hello,
We purchased TI Part # SN74AVC2T45DCTR from Texas Instruments. The shipment was received with the correct TI Part #, however, it was observed that the part marking on this new lot has "DT2 61Z", while our previous lots…
Part Number: SN74AVC2T45 Tool/software: Hi,
We are looking for a level translator to support the following spec
1. VCCA - 1.2V, VCCB- 1.8V, 2.5V
2. Board parasitic capacitance (trace+ Device)- 50pF
3. Data rate- 80MHz
We have gone through the…
Part Number: SN74AVC2T45 Tool/software: Request specific information regarding the lead finish for the part SN74AVC2T45DCTR at HFTF assembly site.
Could you please provide clarification on the following points:
As per PCN 20250307002.1 Dated March…
Part Number: SN74AVC2T45 Other Parts Discussed in Thread: SN74AXC2T45 Tool/software: The device specification does not have a power supply tolerance specification. There is a table that suggests a tolerance "Pg 13" but it does not directly apply to a…
Part Number: SN74AVC2T45 Other Parts Discussed in Thread: SN74AXC2T45 , , SN74AUC2G34 SN74AXC2T45 could we apply in 80MHz signal operating, 3.3v to 0.8v?
Part Number: SN74AVC2T45 Other Parts Discussed in Thread: SN74AVC8T245 Hi Team,
We want to interface an eMMC 5.1 device [which supports a data rate of 400Mbps on each of its 8# data pins and has an IO voltage level of 1.8V] to an FPGA's GPIO pins [which…
Part Number: SN74AVC2T45 Other Parts Discussed in Thread: SN74AXC2T45 Hi Team,
The minimum and maximum propagation delay values (at VCCA=1.2V and VCCB=1.8V) of the part SN74AVC2T45 are not present in the datasheet. Only typical values are provided in…
Part Number: SN74AVC2T45-Q1 Hi Application team;
My customer is request CAVC2T45TDCURQ1 FIT functional safety document , May I know the part have the FIT functional safety report?
thank you
Roy
