Part Number: SN74CB3Q3345 Team,
is it ok (or even needed) to connect the thermal pad to GND?
My customer cannot find that information in the datasheet.
Thanks!
Part Number: SN74CB3Q3345 On page 1 of the datasheet, the pin out diagram for the RGY package shows pin 16 is "B9", and there is no "B3". Is pin 16 supposed to be "B9"?
http://www.ti.com/lit/ds/symlink/sn74cb3q3345.pdf
Thanks…
Part Number: SN74CB3Q3345 HI,
SN74CB3Q3345 datasheet contains content below: "Rail-to-Rail Switching on Data I/O Ports".
Does it mean, the output Voltage Level is the same as the input, regadless of the Vcc supply?
For example, the Vcc supply…
Other Parts Discussed in Thread: SN74CB3Q3345 Question regarding SN74CB3Q3345 in partial power down:
When Vcc, OE, and OE/ are 0V, is there isolation between the A and B lines?
The notes about partial power-down are vague and I can't determine if there…
Hi Kevin,
You can use the SN74CB3Q3345 ? This device has two OE pins, 1 that is active high and 1 that is active low.
To use this as a device with 1 active high OE pin you can connect the active low OE pin to logic high. This achieves the same results. …
Hi Marion,
What do you think of the SN74CB3Q3345? It has OE pin active-high..
What is driving the need for active high OE pin in system? What are using using the switch for?
Thanks
Saminah
Hi Shashank,
The best recommendation for an 8 channel SPST switch is SN74CB3Q3345 .It offers small package size (VQFN) and input voltage upto 5V.
Other for an 8 channel SPST switch can be found at the link here .
Part Number: SN74CBT3345 Other Parts Discussed in Thread: SN74CB3Q3345 It is written in datasheet that when IC is enabled then PORT A=PORT B.But I am getting 1 volt drop at output.What may be the possible reasons for this voltage drop.
