Part Number: SN74HCS21 Hi all.
Is there Thermal derating curve of logic IC?
I would like to know Thermal derating of logic IC such as SN74HCS21.
Best Regard,
Ryusuke
Part Number: SN74HCS21-Q1 Other Parts Discussed in Thread: UCC21710 Hello experts,
I am using this 4 input AND logic for combining fault signal from my gate drives (UCC21710 - four numbers). The fault pin is open drain so we provided 4.7k pull up to …
Part Number: SN74HCS21-Q1 Hello,
If Vcc = 5V, input pull up voltage is 5V, then how much series resistor value required at the input of SN74HCS21-Q1?
Regards,
Abhishek D.
Part Number: SN74HCS21-Q1 Hello TI Team,
The Part MPN SN74HCS21-Q1 has IBIS Model in Design and Development.
So, Can you provide me Pspice Model for the Same part number?
Thanks,
Gaurav Ingle.
Part Number: SN74HCS21 Hi Team,
My customer have a demand to monitor 6 negative input voltage, such as -8V,-7V,-6V... Each input may different, but it is negative.
If anyone of the negative larger than 0V, the system will receive an alarm. If all the…
Part Number: SN74HCS21 Hi Team,
The datasheet just shows a buffer but does not specifically say if the device is open drain like other datasheets. Is this device open drain? The datasheet only shows diode clamps on input/output ports.
Beat Regards, Tom…
Part Number: SN74LVC1G07 Other Parts Discussed in Thread: SN74HCS21 , SN74HCS08 , SN74LVC08A Hi
I have a question about SN74LVC1G07.
VCC(3V3_PEX) voltage level with impact output (Y) voltage level?
If Tri_REG_PG use 3.3V is ok? thanks!
Jeff
That is not possible with a mux.
You could use AND gates (e.g., SN74HCS08 or SN74HCS21) to combine the four RX signals. But this will not work if two nodes try to communicate at the same time.
Part Number: SN74LVC245A Other Parts Discussed in Thread: SN74HCS21 , , SN74AHC1G09 , SN74HCS11 Hi team,
I would like to know the FIT of the SN29500 standard for SN74LVC245A,SN74HCS21,SN74HCS11,SN74AHC1G09.
Sincerely. Ryu