Part Number: SN74LV14A-EP Hi,
Good Day.
Could customer use SN74LV14AMPWREP instead of SN74LVU04AQPWRG4Q1? His application is only invert the TTL signaling at the inputs and nothing more than that? If the Schmitt trigger could be utilized as only invertor…
Part Number: SN74LV14A-Q1 Hi team, MSL levels are different with and without G4. I assume the IC is the same, but why are the levels different? Sincerely. Kengo.
Part Number: SN74LV14A
Hi Expert,
My customer is considering about Vcc startup.
Customer try to check output state at Vcc startup with their board and Spice simulator.
(Conditions)
Vcc_normal = 5V, Input pin = pull up to Vcc at start up.
(Results…
Part Number: SN74LV14A-EP Hi Team,
I am looking for the thermal information of this part SN74LV14A-EP. I checked the datasheet and I was unable to find information. The datasheet points me to a broken link.
I am specifically looking for "the thermal junction…
Part Number: SN74LV14A Other Parts Discussed in Thread: SN74LV540A Hi Team
My customer wants to know the input transition rate of SN74LV14A. It is not shown in datasheet.
I found following material showing LV family have 100ns/V(max) input transition rate…
Part Number: SN74LV14A
Hi,
Is there a possibility for the SN74LV14A with the schmitt trigger feature to latch up if connecting a 10uF capacitor between the input pin and GND? There isn't mentioned regarding tr and tf in SN74LV14A data sheet. So, could…
Part Number: SN74LV14A Other Parts Discussed in Thread: SN74HCS14 Hi Team,
My customer would like to know the variation of SN74LV14A VT threshold.
Do you have any data regarding following 3 specs(Highlighted yellow in follow table)?
1.VT+Positive-going…
Part Number: SN74LV14A Hi Team,
Why are the device markings different. The font and the dot that identify the pin 1 are different.
Beat Regards, Tom Liu
Part Number: SN74LV14A Hi Team,
There are two definition of Vo abs max level in the datasheet as below.
It looks like we have to be careful about the relationship between the Vcc and Vout voltages when the Output is NOT Hi-Z, but what are the conditions…