Part Number: SN74LVC1G11-Q1 Other Parts Discussed in Thread: SN74LVC1G11
Tool/software:
Hi
looking at TI SN74LVC1G11-Q1, its appears as -40 to 85 deg but i think its a mistake as SN74LVC1G11 that is not automotive have temperature range of -40 to 125…
Part Number: SN74LVC1G11 Tool/software: It doesn't seem to allow 3.3V input.
The SN74LVC1G11 doesn't seem to have a positive clamp diode.
What is acceptable?
Part Number: SN74LVC1G11 Tool/software: Hi Everyone,
Using SN74LVC1G11 to feed an RC network - R = 22Ohm, C = 470pF - this will result in peak current of VCC/22 = 5/22 = 227mA for a very short time.
Will this high peak current allowable? will we need…
Part Number: SN74LVC1G11-EP Tool/software: Hi, I'm looking for additional thermal resistances of this part. Only the junction to ambient value of 259°C/W is shown on the datasheet. I'm hoping there are less conservative values for say junction…
Part Number: SN74LVC1G11 Tool/software: Hi
I noticed that the footprint and the STEP file in the web site is incorrect the sot23-6 pads, width and length.
for exempla the pads in the data sheet is 0.9*0.4 and not as in the downloaded design that is 1…
Part Number: SN74LVC1G11 Tool/software: HI Team,
For this 2 input AND gate there is no data given for VOH and VOL for VDD=3.3V and VDD=5V??
Similarly for SN74LVC1GU04DBVR (NOT gate), SN74LVC1G11DCKR ( 3 input AND gate ) and SN74LVC1G34DSFR ( 1bit buffer) …
Part Number: SN74LVC1G11 Tool/software: To the person in charge
About 5 Pin Configuration and Functions of Data-sheeet (SCES487H –SEPTEMBER 2003–REVISED NOVEMBER 2016)
Is the diagram below correct? If it's a 6-pin SC70, I think the terminals…
Part Number: SN74LVC1G11-Q1 Tool/software: Hi team,
I found that my circuit would drive a maximum current of 119mA for about 2ms. Is it safe for this device to drive the overcurrent for a short period of time? If it is not a problem, I would like to know…
