Part Number: SN74LVC1G123 I hope you are doing well.
My customer came across what appears to be a pin numbering issue between the DSBGA package and the pin numbering chart for the SN74LVC1G123YZPR
For the DSBGA package shown on page 27 of the…
Part Number: SN74LVC1G123 Hi
We are using SN74LVC1G123 in one our legacy designs which I am trying to understand. Rext value used is 100k. Cext value is 47 uF. I am not able to calculate the output pulse duration from the datasheet. Can you pleae help…
Part Number: SN74LVC1G123 Hi, I am trying to use the SN74LVC1G123DCTR along with an Inverter in the following configuration, but when the device is powered ON, I see ringing at the Inverter input or the multivibrator output as well as the output of the…
Part Number: SN74LVC1G123 Other Parts Discussed in Thread: SN74LV123A , Tool/software: Hello team,
On the datasheet of SN74LV123A, the section 10.2.1.1 describes that turn-off time of Vcc must be cared, because of discharge from pin2 or 4.
On the…
Part Number: SN74LVC1G123
I'm trying to understand if this circuitry is working correctly, does the monostable send an output signal once it is turned on? Should I pull B high and allow the input to dictate A? Should I also remove the capacitor from…
Part Number: SN74LVC1G123 Hello,
I need to generate an output pulse with a width between 1.2 and 1.5 seconds. Looking at the SLA720a datasheet and application note, the maximum duration is obtained with a 200k resistor and a 1µF capacitor. Can I increase…
Part Number: SN74LVC1G123 Hi team,
I received 2 question about SN74LVC1G123. Please support.
1) Can this device receive an input and outputs a pulse with no wait time from the supply voltage reachs operating supply voltage?
2) What is the output…
Part Number: SN74LVC1G123
[Case:710338]Technical Data Inquiry
SiliconExpert is contracted our customer to work with their suppliers for accuracy and compliance purposes.
Please, we are still in confusion, as the part SN74LVC1G123-DCU recorded as…
Part Number: SN74LVC1G123 Hi Team,
I want to use this IC in my design to latch an interrupt for 1 second.
The input voltage is 1.8V (and so is the interrupt nominal voltage), and the capacitance graph only goes to 10^6 pF.
I want to use R_L…
