Part Number: SN74LVC2G08 Tool/software: Hi,
Plesae advise the detial information for the device marketing, like as (2WJ5, C08) (R,Z) and so on, thanks.
Part Number: SN74LVC2G08-Q1 Dear TI team,
We will receive material SN74LVC2G08QDCURQ1 from brooker R&A, they sent Authenticity test report which is bellow.
Can you check report and confirm a uthenticity of label and batch from the report?
RATR2025102431…
Part Number: SN74LVC2G08 Tool/software: Hi,
I just want to know if this IC can support operating when supplied with 3.3V of supply voltage & one input is provided a swing of 0-5V when another input will be toggling between 0 and 3.3V. Will this IC be…
Part Number: SN74LVC2G08 Hi,
Good Day.
For slow rise 3.3V VCC, 1st input is pulled down to GND, 2nd input is logic high. What will be the Output state when the VCC is rising to 3.3V? Can I expect the output to stay low as one of the inputs is held…
Part Number: SN74LVC2G08 Hi support team.
When have expanded operating temperature range?
Could you tell me which datasheet rev is changed spec?
Best regards,
Higa
Part Number: SN74LVC2G08-Q1 Hi ,
What is the variation of IVCC with respect to temperature?
I find that I_VCC is 4uA at -40 deg and at 25 deg it is around 53uA.
Is my measurement correct?
Part Number: SN74LVC2G08-Q1 Hi ,
I am validating the part SN74LVC2G08-Q1 for one of our project applications and I have a doubt regarding the supply current mentioned in the datasheet. How should the current be measured?
Also i am a bit confused with…
Part Number: SN74LVC2G08 Other Parts Discussed in Thread: SN74LV1T08 , SN74AUP1T08 Hi team,
My customer is looking for an 2-ch, 2 inputs AND gates which can accepts 1.8V for High level.
All I found on the ti.com was 2V for VIH at 3.3VCC. Could you…
Part Number: SN74LVC2G08-Q1
Hi ,
We are using SN74LVC2G08-Q1 in our project application and I am trying to measure the high level and low level input thresholds. I am observing that VIH= 1.671V which is lesser than the minimum value (2V…
Part Number: SN74LVC2G08-Q1 Hi ,
I am using SN74LVC2G08-Q1 in my project application and I while validation I find some discrepancy in the output waveform. I have provided IN1 = 3.3V and have provided a triangular waveform with 10kHz at IN2. We can…
