Part Number: SN75DP119 Other Parts Discussed in Thread: TUSB1146 , TDP142 Tool/software: I want to transmit eDP signals over 2m using a Type C cable, but if I insert the SN75DP119 on the receiving end, will this be possible? Or is it not enough to just…
Part Number: SN75DP119 Dears，
1. Can the length of the SN75DP119 external cable reach 1.5m?
2. For optimal performance, does the design require the SN75DP119 to be placed in its current center position, 75cm on each side?
Part Number: SN75DP119 Hi TI Teams,
Can u help to check the schematic of SN75DP119 and give some suggestion for the design?
SN75DP119 SCH (1).pdf
Thanks,
Kind Regards
Part Number: SN75DP119 Hi ,
I am using eDP repeater SN75DP119 in design.
My Design don't have any GPIO pins to control SN75DP119 pins "Enable ", "PRE_CTL " ,"VOD_CTL" and "EQ_CTL" .
I have below queries :
1. Can I fix above pins with pull up…
Part Number: SN75DP119 Other Parts Discussed in Thread: SN75DP159 , SN75DP130 , TDP142 Do you have an IBIS-AMI for SN75DP119 device? We want to run a channel analysis with a DisplayPort protocol using Hyperlynx Channel Analyzer, at 3Gb/s
If not, please…
Part Number: SN75DP119 Is the driver output impedance correct in the SN75DP119 data sheet? The spec shows it as 100 ohms single-ended.
Based on other parts of the data sheet such as the recommended output termination shown in the Recommended Operating…
Part Number: SN75DP119
Dear,
our client use SN75DP119, but Datasheet layout information was simplified schematic drawing.
could share detail layout guide (like trace length limit)?
Platform : Intel BSW X5-E8000
If any suggestion, Please…
