Part Number: SN75DP159 Tool/software: Hi teams,
My PC customer has the following requirements: eDP 1.4 interface, trace length about 340mm, IC needs to be redriver, does TI have a solution that meets this requirement?
Best Regards
Chris
Part Number: SN75DP159 Tool/software: Hi,
We are planning to implement SDI 12G and because of this the FAB house recommend us to use Rogers for dielectric which makes the pricing to increase. Since our solution is low cost, our layout engineer suggested…
Part Number: SN75DP159 Other Parts Discussed in Thread: TS3DV642 , , TDP158 Tool/software: Hi
In our design, we connect the HDMI connector via AC capacitors , to the TS3DV642 MUX component, and we connect the MUX output to the SN75DP159 inputs without…
Part Number: SN75DP159 Other Parts Discussed in Thread: TMDS181 , TUSB3410 Tool/software: Hi Tier
Can DP159 support the Eye Scan function? If supported, could you give my customer some guide?
Can DP159's TMDS disparity or data errors be used to count…
Part Number: SN75DP159 Hello,
in my application i need to convert DP protocol to HDMI protocol "whit redrive like dp130(DP to DP)", it is DP159 right choice or your suggestion other IC?
best regards Mitja
Part Number: SN75DP159 Tool/software: Hi TIer
My customer want use SN75DP159 to Retimer the 5.4Gpbs 1 lane eDP signal without AUX to improve signal performance.
Does our chip support eDP without AUX operation?
And for this 5.4G eDP signal do…
Part Number: SN75DP159 Hi Experts,
We are currently integrating your device and have a question regarding pin 21 (EQ_SEL/A0). According to the datasheet, this pin is used for equalization selection when I²C_EN/PIN = Low , and also serves as address…
Part Number: SN75DP159 Tool/software: Hi , we are trying pre compliance tests using setup as attached (for simplicity only one data pair is shown) .
Many monitors available on the market, directly short shield to gnd and to earth (of power plug).…
Part Number: SN75DP159 Tool/software: Hi Team,
We faced to EMI issue of SN75dp159 and found an E2E post about EMI/EMC problem.
https://e2e.ti.com/support/interface-group/interface/f/interface-forum/712523/sn75dp159-failing-emc-testing/2679137?tisearch…
Part Number: SN75DP159 Tool/software: Hi,
The schematic for the SN75DP159 as below attached. Our HDMI SI measurements for VSwing and Inter-Pair Skew – D0/D1, D0/D2, and D1/D2 all failed. What methods can be used to adjust these parameters?
VSwing…
