Hi Udit,
I think you will be able to do this on your own by reviewing these references below.
\\docs\SW-DRL-UG-xxxx.pdf
\\boards\ek-lm4f120xl\drivers\buttons.c
\boards\ek-lm4f120xl\interrupts
-kel
"GPIOPinTypeI2C(GPIO_PORTB_BASE, GPIO_PIN_2 | GPIO_PIN_3);"
This is incorrect for LX4F - and new rebrand series. You must instead use, "GPIOPinTypeI2C SCL (GPIO_PORTB_BASE, GPIO_PIN_2);
SW-DRL-UG (newer versions) list and confirm this new requirement…
Andries Danau said: who created these functions
StellarisWare was originated by programmers @ LMI - and subsequently expanded by TI.
Cautionary note - not all Stellaris (the dreaded NRND M3s) accept GPIOPinConfigure() - SW-DRL-UG sounds this alarm…
Hi Gaurav,
you can find the Peripheral Driver Library User's Guide here: http://www.ti.com/tool/sw-drl
Find all the packages and related documentation here: http://www.ti.com/lsds/ti/microcontroller/arm_stellaris/code_examples.page
Rgds aBUGSwo…
Dave Wilson said: call to I2CMasterEnable() .
In the past - shared this belief with you. However - for past 60 days or so - we've run multiple I2C Ports w/out using I2CMasterEnable(). I've just triple-checked! (this on new M4F - should that matter…
Hi Donald,
Donald Rich said: The description of the ADC Digital Comparator Control registers ( ADCDCCTLn starting at offset 0x0E00) defines the bits for configuring Interrupts but not any corresponding bits for configuring triggers.
See Analog Comparator…
Krishnat Pawar said: PLEASE SUGGEST POSSIBLE SOLUTION / POINT OUT ERRORS.
That's quite a task listing - is it not?
You do (neither) yourself - nor your helpers - any favor by electing, "4 Bit LCD Mode." The "saving" of 4 GPIO is achieved at much greater…
Spectacularly valuable, insightful - and caring, "slandrum" post. Bravo. (and SO deserving of Verified Answer tick)
Would be immensely helpful if you'd allow this to be included w/in both MCU datasheet and SW-DRL-UG.
Most all of the SSI intricacies…
