Part Number: TCA4311A Other Parts Discussed in Thread: TCA9511A , TCA9617B Hello, At my customer, a host uC is on the board #1, a slave device is on the board #2 and they are connected each other via a connector. In case VCC1 gets ON first while VCC2…
Part Number: TCA4311A Other Parts Discussed in Thread: TCA9511A ,
TCA4311ADR
fall time of both SDA and SCL signals
rise time of both SDA and SCL signals
data hold time
data set-up time
Maximum junction temp…
Part Number: TCA4311A Other Parts Discussed in Thread: TCA9511A , TCA4307 , TXB0104 , SN74AXC4T774 Hi TI expert
We have one hot swappable buufer for I2C with one interrupt (IRQ) and SPI with one interrupt (IRA), total is 8 pins.
For I2C, we have…
Part Number: TCA4311A Other Parts Discussed in Thread: TCA4311 , TCA9511A Tool/software: TCA4311 not propagating ACK --Will this happen on next bit just after ACK?
There is a similar phenomenon, but after ACK.
Part Number: TCA4311A Other Parts Discussed in Thread: TCA9511A , Hi
Could you help what is the reason, the data cannot be read when reading, as shown in the red circle, The information has been backfilled, please refer to.
Part Number: TCA4311A Other Parts Discussed in Thread: TCA9511A Hi team,
My customer wants to use TCA4311A, and need the IBIS Model for evaluation, but I just find TCA9511 IBIS under TCA4311A Design tools & simulation.
Could you tell me where can…
Part Number: TCA4311A Dear experts,
now our customer used TCA4311A replace PCA9511, but test result is not ok, it seems that the noise immunity of TCA4311A worse than PCA9511, When using PCA9511, it is ok . Switching to TCA4311A will not work properly…
Hey Kane,
This device uses a dynamic voltage offset so as your stack them in series, the VoL gets larger from "TX" to "RX" (keep in mind I2C is bidirectional though).
For example, if you have a VoL of 0.3V on the TX line and the dynamic offset value…
