Part Number: TCAN1043-Q1 Other Parts Discussed in Thread: TCAN1043 , TCAN1043A-Q1 Hi,TI partener:
1. What's the exact time of " UV time"？ 100ms or 200ms?
2. In the use case below, how will the level of INH change? Does the voltage of INH vary periodically…
Part Number: TCAN1043-Q1 Tool/software: Hi TI,
I want to know about INH hold time.
May I know INH High Hold Time after Vsup is Turned On?
(Vcc turned Off, Vio turned Off)
Best regards,
Part Number: TCAN1043-Q1 Tool/software: Hello team,
1. The CAN datasheet recommended using a 120Ω resistor for the terminal node, but in real case, non-terminal nodes may use R1=R2=1.3KΩ as the terminal resistor. a) What is the benefit based on "R1…
Part Number: TCAN1043-Q1 Other Parts Discussed in Thread: TCAN1043 Tool/software: Hello,
In the TCAN1043 data sheet, typical values for mode change time (tmode1 and tmode2) are not explicitly mentioned. Only maximum value is present. What will be the…
Part Number: TCAN1043-Q1
Tool/software:
Hi TI expert,
I test with two cases: CAN_H shorted to GND (1) and CAN_L short to GND (2)
For each case I measure the nFAULT pin. For case (1), nFAULT changed state (expected - OK) but for case (2), nFAULT…
Part Number: TCAN1043-Q1 Tool/software: Pin no: 11 of TCAN1043-Q1 is found to be NC. How do we handle this pin . Is it ok to float or is it be pulled low or high ? In case if we keep it floating due to some reasons would it create any issues ?
Part Number: TCAN1043-Q1 Tool/software: Hello expert,
Do you have the flow chart for normal / sleep / standby mode? I checked with datasheet and there is only below table but customer would like to know how about CANH/CANL receive WUP. So if there is…
Part Number: TCAN1043-Q1 Tool/software: Hi,
I notice that the CANH/CANL output voltage is a range in the datasheet, but actually when we measure it is always the typical value 3.5V/1.5V. I want to know at what condition the voltage will really change…
Part Number: TCAN1043-Q1 Hi team,
For TCAN1043-Q1, if we do not need external wake up(LWU) mechanism, could we connect the VSUP pin to VCC pin directly?
As long as the VSUP is above UVVSUP, it should be fine right?
Since the IC has UVVSUP protection…
Part Number: TCAN1043-Q1 Other Parts Discussed in Thread: TCAN1043 Hi team,
For TCAN1043 application, is below ok? There are RTERM of each node, thanks!
BR
Jiawei
