Part Number: TCAN1051HV-Q1 Other Parts Discussed in Thread: ISO1042-Q1 , , TCAN1051HV , STRIKE
Hi TI Team,
We have two PCB variants of the same design in which we use the TCAN1051HV-Q1 (Non Isolated) & ISO1042-Q1 (Isolated) parts (schematic as shown…
Part Number: TCAN1051HV Other Parts Discussed in Thread: TCAN1051 , Dear TI team,
We are using MAX13054 in our design. We are planning to use alternate part TCAN1051HV. TCAN1051 seems to be the pin-to-pin replacement for the MAX13054. Can you please…
Part Number: TCAN1051HV-Q1 Other Parts Discussed in Thread: TCAN1051HV , TCAN1051 Hi,
please conform following features are available in the TCAN1051HV?
CAN interface allows for compliance with both CAN Open and CAN J1939.
CAN bus shall be a…
Part Number: TCAN1051HV Hi
The datasheet mentioned the fault protection up to ±70 V .
Is there an rough idea how long can the device sustain for ±70 V fault ?
Part Number: TCAN1051HV Dear Sir,
When I tested TCAN1051HV, I found that designer let pin 8 floated.
I check TI document, it depicts that when pin 8 is pulled to GND, the device is in “normal” or high speed mode,
when pin 8 is pulled to VCC the…
Part Number: TCAN1051HV Other Parts Discussed in Thread: TCAN1051 I am looking at TCAN1051, and in the data sheet it specifies only certain parts have the 3.3V integrated level shifter (since the supply voltage is 5V).
Does this mean the part can…
Part Number: TCAN1051HV Other Parts Discussed in Thread: TCAN1051 , SN65HVD230 , ISO1044 Hi.
Currently we are using CAN transceiver SN65HVD230 with success, and we want to substitute it by a TCAN1051 on the next PCB layout because it is 'fault-protected…
Part Number: TCAN1051HV-Q1 Other Parts Discussed in Thread: TCAN1051
We have seen Both CAN FUSE open and ESD diode failure in field . In all cases this failure happened only during Charger Grid. attached block dia FYR Supply disconnection or making&Breaking…
