Part Number: TCAN11625-Q1
Tool/software:
Hi team,
My customer Joyson are using TCAN11625DMTRQ1 for their project. They met an issue that TS pin will not goes high when use low rising slew rate Vsup. Can you please help analysis the cause? Thanks…
Part Number: TCAN11625-Q1 Tool/software: We use TCAN11625, where the RST pin is first reset low, then raised, and then nSLP is raised. The condition for entering Normal is met when Vio is 3.3V, but it cannot actively send data and needs to receive one…
Part Number: TCAN11625-Q1 Hi Teams,
My customer specializes in car key positioning products and has been using the TCAN11625-Q1 product for the past year.
They encountered SLP not pulling high, causing the system to keep shutting down and restarting…
Part Number: TCAN11625-Q1
Tool/software:
Hi team,
1. Can we not use nRST-pin if we not use Reset from external MCU? In other words, is rising edge of nRST needed to exit from Reset-mode?
2. If it is acceptable, can we leave float nRST-pin? It…
Part Number: TCAN11625-Q1 Tool/software: Hello team,
Customer is testing our EVM, found VLDO output issue:
When power off from sleep mode, and then power on immediately, the LDO cannot output 5V. Only wait more than 3.5s and then power on the Vsup…
Part Number: TCAN11625-Q1 Tool/software: Hi Team,
My customer BorgWarner has faced a situation that when they want to burn the program to MCU by CAN. The MCU will pull low nRST because of MCU itself reset. And then TCAN11625-Q1 will enter reset mode…
Part Number: TCAN11625-Q1 Tool/software: Hi team ,
We are using TCAN11625 in one of project we kept the nSLP pin to high and left the nRST pin floating we did not getting the communication in the can lines , When i measure the voltages on nRST it is…
Part Number: TCAN11625-Q1 Tool/software: Hi teams,
TCAN11625-Q1 can receive normal signals after power failure and restart, but after our MCU soft reset, CAN does not send any data. What is the possible remote cause of this problem.
Just to add…
Part Number: TCAN11625-Q1 Tool/software: 1、Module test method
During module testing, see Figure 9-2. Driver Test Circuit and Measurement in the ti specification to see whether it means that no external can tool is used for testing. In the actual test…
Part Number: TCAN11625-Q1 Hi team
Regarding INH pin of the internal block diagram of TCAN11625-Q1, INH terminal is connected to gate of the FET.
I believe this is wrong.
INH pin must be connected to the drain of the p-FET like below, correct…
