Part Number: TCAN330 Tool/software: Hi;
I have two questions for TCAN330.
1) In TCAN330, can SHDN (pin 5) and S (pin 8) be connected directly to GND without a resistor if not used? We do not want to connect these two pins to the MCU.
2) My other…
Part Number: TCAN330 Hi Team,
In reference to the original post, the silent mode of TCAN330 turns on when the output S is high. With hot swapping, power and high levels will arrive with a delay. Will there be false information on the bus?
Kind Regards…
Part Number: TCAN330 Tool/software: In Figure 37 on page 28 of the specifications, are the waveforms of TXD, RXD, CANH, and CANL measured by inputting High and Low to TXD and measuring RXD at the same time?
Is the waveform input to TXD transmitted…
Part Number: TCAN330 Other Parts Discussed in Thread: TCAN3404-Q1 Tool/software: Hi TIer
My customer needs a CAN chip that can support 3.3V power and can connect to the MCU's CAN interface, so it should be a chip without a protocol stack. Is the TCAN330…
Part Number: TCAN330 Other Parts Discussed in Thread: ESD2CAN24 Tool/software: I am using the TCAN330 CAN transceiver, which supports a maximum CAN-H/CAN-L voltage range of ±14V. To add external ESD protection, what is the recommended breakdown voltage…
Part Number: TCAN330 Hi,
From the datasheet of TCAN330DR, I saw the Bus dominant mode fault current would be 180mA considering the condition of CANH stuck at -12V.
I am assuming this would be arrived as below,
maximum faulty current = Faulty voltage…
Part Number: TCAN330 Tool/software: Hi, Support Team
our client use TCAN330 and test CAN Bus timing measurment result as below chart:
about test result have any concern?
schematic:
if any suggestion, Please advise me.
Thanks,
Best regards…
Part Number: TCAN330 Other Parts Discussed in Thread: SN65HVD232 , TCAN332 Hi,
The customer has a demand for a CAN bus transceiver, which requires CAN signal input and RS signal output. Whether SN65HVD232 is the best solution?
Regards,
Charlie
Part Number: TCAN330 Hi,
Please help to provide the basic version of the CAN transceiver that conforms to the ISO11898 standard, thank you!
Regards,
Charlie
Part Number: TCAN330 Other Parts Discussed in Thread: TCAN332EVM Hi.
A question about the Test Points in CANH & CANL in TCAN330 EVM board.
The board has TPs directly connected to the CAN signals and other TPs connected to the signals through a resistor…
