Part Number: TCAN334 Tool/software: Hi Team,
I am using TCAN334 CAN Transceiver Chip which operates at 3.3VDC for one of our Application which is interfaced with Master MCU ST32H753ZIT6.
Its Operating speed is 250kbits/sec it is connected to 12Slave…
Part Number: TCAN334 Tool/software: I made a board with TCAN334DCNR, and this board is interfacing with FPGA board through CAN protocol. TCAN334DCNR powered up with 3.3V and SN55HVD251DRJR (FPGA board) powered with 5V. Please look into the block diagram…
Part Number: TCAN334 Hi
Does the CAN bus need to be impedance controlled in layout? With the following placement reference differential signal routing is not possible. Any suggestions?
Currently in my layout the D1 to J1 distance is 1 inch.
Part Number: TCAN334 Tool/software: Hoping to get get some guidance on correct grounding for a CAN Bus I have designed. The following diagram gives a high level overview of the system connectivity:
Some notes on the setup:
There are a total of…
Part Number: TCAN334 Other Parts Discussed in Thread: TCAN3414 Tool/software: Hello experts,
We are using the TCAN334 (soon we will switch to the TCAN3414) along with the 6432 IWRL radar chip. Our device seems to work robustly alone on a network with…
Part Number: TCAN334 Hi team,
In TCAN334 datasheet, we can find the abs voltage for CANH/CANL is +-14V. The 14V here is that when VCC is powered, right? And if we connect the CANH/L to CAN bus, and don't power VCC, will the IC be damaged ?
In my customer…
Part Number: TCAN334 Other Parts Discussed in Thread: ESD2CAN24-Q1 Hello,
We’re investigating adding some additional protection on CANH and CANL to avoid damaging the TCAN334. The TVS part we’re investigating for this purpose has a typical channel input…
Part Number: TCAN334 Other Parts Discussed in Thread: SN65HVD230 We are using the internal CAN controller of the STM-32F103 MCU with a TCAN334 transceiver. However, we discovered unexpected behaviour with this combination and could not establish any communication…
Part Number: TCAN334 Hello
The data sheet provides recommend values for R5 and R6 for the suggested layout on page 31, but does not provide recommended values or a range of values for some of the other resistors and capacitors. We were wondering if…
Part Number: TCAN334 Other Parts Discussed in Thread: TCAN1044V Hi Team,
There is a good new that DIN TCAN & TLIN
Does TCAN334's TX & RX voltage could support 3.3V & 5V?
If not! Could you recommend suitable solution to me? THX
