Part Number: TDA3MV I'm Moreno electronic engineer of SMH Technologies, I have some questions about the TDA3M device, I have to program a MICRON memory through it.
My problem is this:
I con nected to the TDA3M device via JTAG, I configured the ICEPick…
Part Number: TDA3MV dear
1. Does it support 1080P 60fps 4-camera input or 720P 60fps 4-camera input?
2. support video output 1080P 60FPS?
3. Does it support 3D viewing and transparent chassis display?
4. Does the system delay requirement…
Part Number: TDA3MV Dear Champs,
When customer removed osc1 in their custom board, they found below issues related with QSPI flash.
Is there any relation between SYS_CLK2(or osc1) and QSPI flash?
1. When qspiFlashWriter_m4)release.xem4 load…
Part Number: TDA3MV Hi TI experts,
1,Does TDA3MV support 1280H*1080V@60fps 4-camera input? over MIPI interface
2,Dose TDA3MV support Drive Video recording?
Part Number: TDA3MV Hi TI expert
We are currently testing various outputs using TDA3. Among them, I want to check the BT656 output. Is there an example code to use BT656?
Best regards,
Thomas
Part Number: TDA3MV Hi team,
Depending on the TDA3EVM to design the board, the following issues occur when running the program:
Here's the config message, could you help locate where this error occurred?
/home/cy/PROCESSOR_SDK_RADAR_03_08_00_00…
Part Number: TDA3MV
Hello.
We are using TDA3MV products, and we need to use I2C slave mode in our project. The SDK version I use is 3.5.
Is I2C slave mode possible?
best regards
Part Number: TDA3MV Hi
I have a problem about a blinking square box at the end of the video.
It works fine at 30hz, but there is a problem at 60hz.
And in number 1 below, a square box appears, but in number 2, it operates normally at 60hz. …
Part Number: TDA3MV
NOTE:
Boards, the board is built by the customer himself with the TDA3MV chip that connects the JTAG.
ISSUE:
When the new TDA3MV single board (no program has been written) is powered up, the multimeter measures that all voltages…
Part Number: TDA3MV Dear Champs,
Could you please share the examples of I2C slave with interrupt mode?
My customer is trying to implement I2C slave mode with interrupt, but faced many issues.
It would be very helpful if there is any example for…