Part Number: TDA4VE-Q1 Other Parts Discussed in Thread: TDA4AL-Q1 , , TDA4VL-Q1 Tool/software: which PSDK should be used to build the BSP + OS image with Qnx8 for the TDA4VE-Q1/TDA4VL-Q1/TDA4AL-Q1 board.?
please provide link to download or steps.
…
Yong Zhang said: Customer know that PLL8_SS_CTRL Register bit[0] need be set to 1 when A72 frequency set to 1.2GHz. has fix in latest SDK.
We were not aware of this e2e before it was mentioned, we were only informed here.
Yong Zhang said: For VE,…
Part Number: TDA4VE-Q1 Tool/software: Hello TI expert.
As shown in the picture shows that the DSI and CSI port signals' operating voltage is 1.8V. However, the corresponding signal from the SERDES operates at 1.2V. Does this ok? Or i just miss something…
Part Number: TDA4VE-Q1 Tool/software: Hi, Experts
Our previous SDK version was 0806, with two 2G DDRs. After correct configuration, the board could boot normally. Now we have upgraded to SDK RTOS version 1106 and directly use the previous DDR parameters…
Part Number: TDA4VE-Q1 Other Parts Discussed in Thread: AM67A , AM67 Tool/software: Hi, Dear Expert
Few question need double check.
(1) As far as I know, TDA4AL/VL/VMid-ECO do not support RGB-IR sensor?
(2) Only TDA4-Entry and AM67A support RGB…
Part Number: TDA4VE-Q1 Tool/software: hi Engineer
When I used the SPI interrupt mode to send data. The SPI module has malfunctioned, manifested as the CS line remaining constantly at a low level, and the last data transmission failed. am using mcspi6…
Hi
Gaston yan said: The camera we use is 300W, 1920*1536 30fps, what is the appropriate cma size configuration, is sram 128k enough
Please keep sram unchanged. You can enlarge cma if error like OOM happens.
Gaston yan said: The print information…
