Part Number: TDP1204 Hello,
We want to use TDP1204 as the DP++ to HDMI1.4 level shifter. The source side DP++ from COMe will not be more than 4-5'' routing length on the board. We don't want software to be involved in the configuration for this chip.…
Part Number: TDP1204 Hi,
We are considering using TDP1204 for our HDMI application.
Is it possible for you to provide TDP1204EVM Design files? DSN file and Layout file as well.
We only find user guides on the website.
Thanks.
Part Number: TDP1204 Hi team,
Customer has been placed dumping resistor to reduce EMC between redriver and connector.
Do you have suggested value for dumping resistor? Or do you recommend not to put the resistor?
Best regards,
Hayashi
Part Number: TDP1204 Hi team,
1. My understanding is that it is possible to swap lanes by I2C or pin strap, Is it possible to swap N and P lines in the same lane?
2. Is it possible to swap P/N lines on the same lane without using I2C settings or pin straps…
Part Number: TDP1204 Hi team,
1. Are below situation generating any issues when Windows modern-standby?
VCC33 and VIO are shut down and EN=L
VCC33 and VIO are shut down and EN=H
VCC33 and VIO stays supplied and EN=L
2. Does I2C communication required EN…
Part Number: TDP1204 Other Parts Discussed in Thread: TMDS1204 Linear Mode:
In linear mode the data received from the GPU’s transmitter is the data that will be sent out of the TX end of the redriver. This means that the GPU’s voltage swing, pre-emphasis…
Part Number: TDP1204 Hi team,
For example, SCL/CFG0 and SDA/CFG1 is pulled high to external pull-up source 1.8V. During the EN=L, Is there no issue on the device? Could you let me know the internal block a bit more?
Best regards,
Hayashi
Part Number: TDP1204 Up until HDMI 2.1, source output AC coupling was not clearly defined. However, now with HDMI 2.1 AC coupling is clearly defined. However, how can the designer determine when to AC or DC couple the HDMI 2.1 output?