Part Number: TDP142 Figure 22 of the datasheet shows how to avoid vias in the DisplayPort lanes by having the GPU DP2_ P connect to the TDP142 IN_DP2 N which will come out on TDP142 OUT_DP2 N but connect up to the DisplayPort connector DP2 P . Similarly…
Part Number: TDP142TDP142.pdf
The EDP signals output by the FPGA are buffered via TDP142 to the EDP connector to drive the display panel, including differential pairs, AUX signals and the hot-plug detect (HPD) signal from the connector. Please review…
Part Number: TDP142-Q1 Other Parts Discussed in Thread: TDP142
Hi, Support Team
Could share about IBIS model and .sxp file of TDP142-Q1?
For SI simulation.
if any, Please advise me.
Thanks,
Best regards,
Lawrence
Part Number: TDP142-Q1 Hi, Support Team
We saw the datasheet of TDP142-Q1 about PIN13 and Pin14 have two question:
Q1: "pull up this pin to the VCC I2C supply of the I2C controller " should I external pull resistor with 1.8V? if yes, any suggest resistor…
Part Number: TDP142 Hello,
My customer wants to connect an AP that supports only DP1.4 and a Display Panel that supports only eDP using the TDP142.
The specifications are as follows:
1. Resolution: 7680 x 936 (@60Hz)
2. Input Interface: Standard…
Part Number: TDP142 Hi All,
I have a question about the TDP142.
Is it okay to leave the unused input pins (INDP2p, INDP2n, INDP3p, INDP3n) open?
Is it necessary to add a failsafe circuit?
Best Regards, Ishiwata
Part Number: TDP142 Hello,
My customer is looking for a redriver IC for the following conditions.
- AP (DP 1.4 Support)
- Sink: 7.8K eDP Panel (MST 2 stream, Single TCON Stitching Structure)
- Transmission Rate: HBR3
- Number of Channels: 4…
Part Number: TDP142-Q1 Other Parts Discussed in Thread: TDP142 Hi Teams,
We are using the TDP142RGFRQ1 in our design. Please refer to the attached schematic and help review whether the connection architecture is correct.
Is this configuration considered…
Part Number: TDP142 Other Parts Discussed in Thread: TMUXHS4512 , TMDS181 Hi Sir,
we will use the TDP142 redriver for the DP1.4 interface applciation.
we have reviewed the circuit and did not find any issue, could you please help review it and advise…
Part Number: TDP142-Q1 Other Parts Discussed in Thread: TDP142 Hi Teams,
Regarding Pin24: HPDIN/RSVD9:
Could you please confirm whether the HPDIN (Hot Plug Detect received) pin can accept a 1.8V input signal? Low = 0V High = 1.8V
Regarding…
