Part Number: TFP403 Other Parts Discussed in Thread: TFP401 Hello,
I am looking for an HDMI to LVDS converter to drive a 7" non-touch LCD . And we want to proceed with two converter components, on one hand an HDMI to DVI or RGB and on the other hand…
Part Number: TFP403 The datasheet for TFP403 specifies setup and hold times for QE vs ODCK. Since both QE and ODCK are outputs, should the timing not show CLK -> Data numbers instead of setup/hold.
What is the min and max CLK-> DATA numbers for QE outputs…
Part Number: TFP403 Other Parts Discussed in Thread: TFP401 , TMDS181 , TMDS171 Hi, i have a Raspberry pi and want to drive a Touchscreen from Pimoroni, called Hyperpixel 4.0-Touch.
My Touchscreen requires rgb666 protocoll.
My Problem is, that i want…
Part Number: TFP403 Other Parts Discussed in Thread: TFP401 , Hi,
i am using the TFP401 at the moment but the minimum DE Low time of the TFP401 is too long (128 pixel clocks), so i am thinking of replacing it.
The minimum DE Low time of the TFP403…
Part Number: TFP403 Other Parts Discussed in Thread: TFP401 , , TFP401A Hello,
I have a general question about technical data missing in the datasheet:
The specification of the guaranteed high and low output voltage (Voh and Vol) is missing. Can…
Part Number: TFP403 Other Parts Discussed in Thread: TFP401 , I wish to know a few things about TFP401, TFP403 DVI receivers
First of all, I dont need CTL lines, what to do in this case?
Here is my question in image form.
Thank you for all…
Part Number: TFP403 Hi,
We had done a circuit having TFP403 connected to FPGA. When connected to a HDMI/DVI source, the device is not getting detected. For example, when i connect by board to HDMI connector available on my laptop, the TFP403 is not…
