Other Parts Discussed in Thread: THS1007 Dear sir,
I have configured my ADC(THS1007) for 4 channel auto scan mode, when i track the sync pulse it is pulsed out from the chip and not as shown in datasheet..
Kindly provide me clarifications...
Other Parts Discussed in Thread: THS1007 I have changed the reference supply from external to internal and found the ADC ( THS1007 ) is working for the below hardware configuration.
The ADC with single channel ( channel 1 ) configured. The internal…
With respect - how would you process data of four external ADC's running four times faster than built-in ADC of msp430? Are you sure this microcontroller is fast enough for that?
To answer your initial question - msp430 forum have nothing to do with…
Other Parts Discussed in Thread: THS1007 , THS10064 Sir,
Can I use this ( THS1007 )ADC's channel input as within the range of 0-3.3V by using Vrefm=0V and Vrefp=3.3V.
Another quesion is, do I have to change my CS0, CS1 and RD input of ADC at each…
Other Parts Discussed in Thread: THS1007 Hi,
Actually I am interfacing THS1007 with FPGA NEXYS-2 Board and for designing the pcb layout of THS1007 , can i provide the voltage supply of BVdd , DVdd and AVdd =5 V each . Please provide your answer as soon…
Other Parts Discussed in Thread: THS1007 Sir,
In ths1007, for every conversion , should i have to change or alternate the value of bit 2 of CR0 register after every clock . If'll do this work in that case we required 2 cycles , one for writing into…
Other Parts Discussed in Thread: THS1007 Hello,
I am trying to connect a THS1007 in my design. I see that the D[9:0] and RA[1:0] are reference to the BVdd signal, and can be hooked to 3.3V. The data sheet is not clear about the conv_clk, sync, R/nW…
Hello Calum,
We don’t have a part that directly substitutes the THS1007 pin by pin with a 3V input range, which is why I believe the circuit from the previous post is the easiest solution.
There are options, but before suggesting other converters…
