Part Number: THVD1451 Tool/software: Hello,
I am using this part in multiple areas of a board we are designing. In order to keep similarity in parts for multiple circuits, I am not using the receivers in a couple circuits. I was wondering what the connections…
Part Number: THVD1451 Tool/software: Hello, TI teams.
I have a few questions about THVD1451 .
1. I would like to know which of the A, B, Y, and Z pins are receive or driver.
2. I would like to know which of the A, B, Y, and Z pins are positive or negative…
Part Number: THVD1451 Tool/software: What are the ramifications from using x2 THVD1451:
1. on the same bus
2. on different PCBs, separated by a cable
3. running at different supply voltages (one at 5V, the other at 3.3V)
From what I can tell, the THVD1451…
Part Number: THVD1451 Tool/software: Hello,
I plan to supply 5V to the Vcc of this transceiver and input a +2V to +3V signal to the A/B Bus input.
The High/Low thresholds of the devices connected to the bus are defined as follows, but since the transceiver…
Part Number: THVD1451 Hi Team,
Could you please kindly help to check if customer could leave D,Y,Z pin floating if they don't use the function thoes pins? Thanks a lot for your support to check.
Best regards
Jie
Part Number: THVD1451
Hi team,
our customer wants to use the THVD1451 in their design, at VCC = 3.3V.
However, all timing specs are for the VCC = 5V conditions (page 11, section 7.8 Switching Characteristics)
Can you please provide data for VCC = 3.3V…
Part Number: THVD1451 Hello team,
I received a question from the customer.
The customer is considering using this device at Vcc:3.3V, but the 7.7 Electrical Characteristics and 7.8 Switching Characteristics at Vcc:3.3V are not listed in the datasheet…
Part Number: THVD1451 Other Parts Discussed in Thread: THVD1450 Dear Specialists,
My customer is considering RS485 PHY with pulse trans former.
The customer uses ARCNET (2.5 Mbps, termination 100 Ω)
ARCNET uses half-duplex RS485 transceiver.
A…