Hi Bhaskar,
Yes. The Current Sink Circuit sits between the INx pin and GND and there is a small voltage drop across the transistors that make up this circuit preventing voltage at the INx pin from being equal to GND. Therefore, when you are using battery…
Part Number: TIC10024-Q1 Other Parts Discussed in Thread: TIC12400-Q1 Hello,
I am planning to use the TIC10024-Q1 in a 12 V automotive ECU.
I want to connect 10 switch to 12 V battery to pins IN0-IN9 of the TIC10024-Q1.
Does the TIC10024-Q1 support test…
Part Number: TIC10024-Q1 Other Parts Discussed in Thread: TIC12400-Q1 Hello,
I am planning to use the TIC10024-Q1 in an automotive ECU.
Since, as stated in the datasheet, the TIC10024-Q1 is designed and tested according to the ISO 16750-2: can I assume…
Part Number: TIC10024-Q1 Other Parts Discussed in Thread: TIC12400-Q1 Hi Team,
We are using TIC10024-Q1 MSDI for one of our design,
Kindly help us to get below files/details!
1) Is there any Spice model available for this IC (TIC10024-Q1)
2) There is…
Part Number: TIC10024-Q1 Hi,
We are using TIC10024 with 24 inputs connected. We did below configuration to read the comparator status.
read device id: MOSI -> 0x2000000 MISO -> 0x241 Read INT_STAT_Read MOSI -> 0x4000000 MISO -> 0x1
Read IN_co…
Part Number: TIC10024-Q1 LEAR AUTOMOTIVE | JLR RIO BCMA project
We have the values below based on the TIC12400_Current_Calculator.xlsx provided by Frederic and we want to know what are the factors considered in the "Worst Case" values. Should we consider…
Part Number: TIC10024-Q1 Hi Experts,
it is difficult to find answer on E2E so I start new thread:
In what state will be IN11 (as example) when we set WC_IN11 register to 0h (no wetting current, current source OFF) and IN_EN_11 to 0h (Input channel IN11…
Part Number: TIC10024-Q1 Hi team,
could you help to answer the following questions ? thanks
1.When the CPU sends data to TIC10024-Q1, does the last bit need to be calculated by the CPU or the TIC10024-Q1 internal hardware implementation?
2.When TIC10024…
Part Number: TIC10024-Q1 Hi Team,
Good day.
Would you kindly tell me what is the effect when CAP_A, CAP_D, or CAP_PRE, are shorted to ground or an open circuit?
Thank you in advance.
Regards,
Marvin
Part Number: TIC10024-Q1 Hi,
I'm the hardware engineer working on Part 5 of ISO-26262. I'm doing the analysis of the effects of random hardware failures, and I need some clarification of some failure modes included in the safety documentation of the TIC10024QDCP…