Hello Karunakaran,
Welcome to the E2E forum! At the moment we do not have sample code or guidelines for the ADS8355.
The C2000 development page does have some resources that could help to start with. Depending on the type of project you had in…
Hello Jan,
Refer below block in the TRM
Figure 12-6. Functional Block Diagram
Jan Bock said: According to the data sheet of the AM243x, sampling with the ADC is NOT SIMULTANEOUS but only sequential. How can we sample the two sin and cos values of…
Part Number: RM48L952 Other Parts Discussed in Thread: ADS8355 , TIDA-00176 , ADS8354 Hi,
I want to use ADS8355IRTET with RM48L952.
The ADS8355 has an SPI interface with two outputs, one for channel A and one for channel B data. How can I connect…
Hi Martin,
After talking with the client, he wants to do the first tests with: linear motor (tecnotion UM3-N) and linear encoder (Renishaw; BISS-C 36bit, 1nm). In a few months I'll do the tests with the VCM.
As you suggested, I'll look into TIDA…
Part Number: TMS320F280025C Other Parts Discussed in Thread: TIDA-00176 Hi Expert,
Customer is interested in TIDA-00176 solution, they'd like to know if F280025 has the ability to achieve the sin/cos encoders inside.
Could you please give the comments…
DRIVE SMART said: 2.Is there any reference document on PM_sincos library? (other than documents given in controlsuite)
Not yet. But you can take a look at the TID as the link below.
https://www.ti.com/tool/TIDA-00176
TI Designs Interface to Sin…
Hi, There are no reference designs readily available to address this requirement. You can explore this option - Analog isolation of the 1Vpp signals using AMC1311 and an isolated 5V supply for the encoder, using SN6501 + transfomer. For rest of the implementation…
Part Number: TMS320F28069 Other Parts Discussed in Thread: TIDA-00176 , CONTROLSUITE , C2000WARE Hi,
I cannot understand the sin/cos encoder phase shift correction method in TIDUA05A. When I programmed in DSP with this method, the position will step…
Jenson said: 1.Since I don't use EQEP, can I just use fine angle?
Jenson,
In section 1.3.2.2 - Table 1 shows different modes for the library. In mode 0 and 1 the fine angle and the coarse angle are calculated in software and the eQEP is not used.…
Roy,
I'm glad you got it working.
roy bordey said: I can't find TIDA-00176 encoder . I badly need one for my motor.
I think one of the TI engineers will need to weigh in about this board.
