The TI E2E™ design support forums will undergo maintenance from July 11 to July 13. If you need design support during this time, open a new support request with our customer support center.
Part Number: TIDA-00299 Tool/software: ALL HI
Looking at the design guide for TIDM-000299, I see two SPI rates listed in Table 3: 16MHz (slave) and 48MHz (master).
For the use of such a high rate in the SPI hardware design of what matters need to pay…
Part Number: TIDA-00299 Other Parts Discussed in Thread: TMS320F28P650DH
Tool/software:
Hello,
Just wondering if TI will support the ET1100's EBUS I/F.
Also - is the
TIDM-DELFINO-ETHERCAT
the only design with the ET1100 TI has?
TIA, John W.
Part Number: TIDA-00299 Other Parts Discussed in Thread: AMIC110
I am new to EtherCAT and assessing it for a potential application. In my current application, I am controlling a SPI device from a Host PC via an FTDI USB bridge device. Each burst of SPI…
Part Number: TIDA-00299 Other Parts Discussed in Thread: TPD4E05U06 , DP83822I Dear Specialists,
My customer is interested in TIDA-00299 and has a question.
I would be grateful if you could advise.
---
TIDA-00299 uses TPD4E05U06 for ESD protection.
TPD4E05U06…
Part Number: TIDA-00299 Hello team,
My customer has questions for TIDA-00299 of 2.2.1.2.3.1. Please support him and me.
The document says "due to the potential difference being outside of the specification of the PHY". Where is the potential…
Part Number: TIDA-00299
Hi,
My customer is considering using DP83822 and refers TIDA-00299 schematic.
The center tap of the pulse Trans is divided as below on this TIDA;
On the other hand, the center tap is connected directly as below on the EVM.
Could…
Part Number: TIDA-00299 Other Parts Discussed in Thread: DP83822I , , DP83826I
Team,
For a comparable setup as in TIDA-00299 do you see any issue by using DP83826I instead of DP83822I for Ethercat slave? In term HW design change what would be the main aspects…
Part Number: TIDA-00299 Other Parts Discussed in Thread: DP83822I Hi,
My customer is evaluating DP83822I, They wonder if this device passed the Ethercat certification. TIDA-00299 shows it passed this certification. would you please show me this certificate…
Hi Nathan,
I have some clarifying questions:
- Is the bus topology required? Our Ethernet PHYs support point-to-point connections, so there may be additional switches / controllers required to achieve the same topology.
- Are there speed or latency requirements…
Hello Nikhil,
Thank you.
Below are a few TI designs that could be referenced for connections,
https://www.ti.com/tool/TIDA-00299
https://www.ti.com/tool/TIDM-DELFINO-ETHERCAT
https://www.ti.com/tool/TIDEP-0105
Regards,
Sreenivasa
