Part Number: TIDM-SERVER-PWR-MON Other Parts Discussed in Thread: EVM430-I2040S
Hi Team,
I am trying to port the existing code to IAR 7.1 and followed the document in the below post. Still I am not able to get through and got struck with linker…
Part Number: MSP430I2040 Other Parts Discussed in Thread: TIDM-SERVER-PWR-MON , MSP-EM-DESIGN-CENTER Where can i find the library of TIDM-SERVER-PWR-MON that the documentation is talking about to use with IAR ?
Part Number: MSP430I2040 Other Parts Discussed in Thread: TIDM-SERVER-PWR-MON I'am having problems to communicate the DC measurement board to the GUI, i already done it before but all of a sudden the board doesn't communicate anymore.
The J5 jumpers…
Part Number: TIDM-SERVER-PWR-MON Hi
Does TIDM-SERVER-PWR-MON support SAG/SWELL, the metrology section shows it is implemented, but application is referencing to already built library.
What command required to read SAG/SWELL event?
Thanks
…
Part Number: MSP430I2040 Other Parts Discussed in Thread: ENERGIA , CCSTUDIO I am having some doubts about how can i read the consumption information by the UART of this board.
In the oficial documentation there is an exemple of a code but i only…
Part Number: MSP430I2040 Other Parts Discussed in Thread: TIDM-SERVER-PWR-MON , Hi Champs,
I downloaded the TIDM-SERVER-PWR-MON software and check the code. there is a CCS workspace. However, there is no file in the project folder. I tried to import…
Part Number: MSP430I2041 TI,
How do we obtain such a low level of %error when using internal Rosc mode for DCO?
tidu454a, page 13, schematic shows 'Rosc' floating? For internal resistor DCO mode, it should be tied to AVSS. For external mode, there…
Hi Charles -
So first - I did get this project working now in IAR.
As for the files I was referencing it is found here - after run the install in tdc 596 zip
\TIDMSERVERPWRMONSoftware-1.0\TIDM-SERVER-PWR-MON-SOFTWARE\Submeter i2040 8k_DC_THD_AUTO_OSR_IAR5…
Hey Naveen,
What is the line voltage amplitude and frequency? What is the minimum signal bandwidth required? Are you set on a certain microcontroller and just need sensors?
If you need isolation sensors, then you can examine the following products…
