The analog front end is required amplification when making gas flow measurements at a few hundred kilohertz. For water flow measurements, extra amplification isn't typically necessary; the PGA within the MSP430FR6043 is sufficient so the analog front…
Part Number: TIDM-ULTRASONIC-WATER-FLOW-MEASUREMENT Hello,
I am trying to interface the TIDM-ULTRASONIC_FLOW_TDC to my laptop using the MSPFET and the TDC1000-TDC7200 GUI. However when I plug the MSPFET into the board after connecting the appropriate…
Part Number: MSP430FR6043 Other Parts Discussed in Thread: EVM430-FR6043 Hi,
I'm working on the Water Flow Measurement project. By deafult, the Design Center GUI is used to communicate with the board and do the measurements. Because of my project requirements…
Hi Maynard,
It looks like CCS is unable to locate the compiler version it is expecting to use.
Can you verify if the customer has the v6.0 compiler installed?
If not, MSP430 compiler version 6.0 can be obtained through the update feature built into CCS…
Hi Jack,
For now I'm going to mark this posting as resolved until we get a chance to debug your board. I can re-open once we have a solution or remedy for the behavior.
Part Number: EVM430-FR6043 Other Parts Discussed in Thread: MSP430FR6043 Hi,
We are starting a design of an ultrasonic spirometer using ti MSP430FR6043 and we are looking for recommendations for the design using the same.
Could you please help us with some…
Thank you so much for your answer. I'm sorry for the delay. We've been solving some issues with the ADC signal first, then we started modifying some issues with our meter physical design so we are about to test new results.
As fast as we finish…
Part Number: TIDM-ULTRASONIC-FLOW-TDC Other Parts Discussed in Thread: TDC1000 , TDC7200 Hi,
Customer is using the TIDM-ULTRASONIC-TDC board and encountering some inconsistency in their design. More details below.
"
I'm dealing with the TIDM-ULTRASONIC…