Part Number: TIOS1013 Other Parts Discussed in Thread: TIOS1015 , , TIOS101 , TIOS102 We are looking to use either the TIOS1013 or TIOS1015 to implement industrial digital outputs.
The TIOS101x devices will be incorporated into an existing hardware design…
Part Number: TIOS1013 Other Parts Discussed in Thread: TIOS101 Dear team,
We can see residual voltage per current like below on datasheet.
But the customer want to know residual voltage under 50mA. Is there any equation to calculate the residual voltage…
Part Number: TIOS1013
Dear team,
I found current limit equation is like below on other E2E thread. is it correct equation?
I_threshold = (350 mA) * (20 kOhm / (R_set + 20 kOhm))
If Rset is 100Kohm, the calculation value is 58.3mA. Is it correct?
How…
Part Number: TIOS1013 Dear team,
The customer are considering dual mode load operation. They want to connect NPN type and PNP type load same time.
Is there any solution like 2ch output type of TIOS1013?
Thank you.
Part Number: TIOS1013 Dear team,
Is there any power limit specification of current limit resistor?
I know the Rset value is using to make internal comparator input voltage. is it right? If yes, How much current flow across Rset resistor?
We have to decide…
Part Number: TIOS1013 Hi,
I am thinking about using the TIOS1013 in Push-Pull mode. Will there be a Power-Up-Delay of 30ms (with Output Voltage 12V) as mentioned in figures 9-5 and 9-6 of the datasheet for High-Side and Low-Side mode ?
Part Number: TIOS1013 hi,
We are doing functional as well as EMC testing for TIOS101-3 at the moment and hope that the performance of the TI chip meets requirements.
We have one particular issue at hand regarding immunity to transient surge voltage. If…
Part Number: TIOS1013 Other Parts Discussed in Thread: TIOL1113 , LDC1612 Hello,
I'm currently having problems programming a board via ISP after a couple of uploads of it working normally.
The TIOS1013's LDO powers the circuit in normal operation, but…
Hi Ueli,
We have a new version of this device in development that should correct this issue and samples should be available in the next couple of months. It is pin-to-pin equivalent with the TIOS101 and should be able to be a drop in replacement once…
Hello Josef,
Thank you for your interest in the TIOS101 and I would be happy to answer any questions you may have.
1. Can you please confirm that the TIOS101 cannot operate on low-side only mode with VCC_IN=5V and VCC= floating?
No, all versions of the…