Part Number: TL16C2552 Dear Specialists,
My customer is evaluating TL16C2552IFN and has a question.
I would be grateful if you could advise.
---
In TL16C2552IFNR, Interrupt signal continues to be output from UART (TL16C2552)
The data sheet states the following…
Part Number: TL16C2552 Other Parts Discussed in Thread: NS16C2552 Hi,
My customer is evaluating TL16C2552 for replacing NS16C2552.
But customer found any INT wasn't asserted with TL16C2552.
(Regarding MCR bit3 of TL16C2552 and NS16C2552, it's assigned…
Part Number: TL16C2552 Dear Technical Support Team,
Is it only the temperature range of TL16C2552IFN and TL16C2552FN? For example, is there a difference in power consumption, etc.? Since the data sheet is the same for I and C products, are the characteristics…
Part Number: TL16C2552 Dear Technical Support Team,
Let me check the interrupt. Is it possible to switch between edge sense and level sense for TL16C2552IFN interrupts(INTA and INTB)?
Is there difference of interrupt behavior between TL16C2552 and PC16552…
Part Number: TL16C2552 TI parts without ESD information on datasheet
Hi team,
TI P/N
ESD_HBM
ESD_CDM
TL16C2552FNR
TL16C752DPFBR
SN75LVDS386DGGR
SN75LVDS387DGGR
TL16C550CPTR
TL16C554AIFNR
TL16C554IFNR
TLK…
Part Number: TL16C2552 Dear Specialists,
Our customer is considering changing from PC16552 to TL16C2552 and they has a question.
I would be grateful if you could advise.
---
Comparing the registers of PC16552 and TL16C2552,
There was a difference in the…
Part Number: TL16C2552 Dear Sir or Madam,
We are considering using TL16C2552 as an alternative to PC16552D.
I checked RESET compare and Timing and it was okay.
But it still doesn't work.
Has anyone succeeded in the replacement?
Best regards,
Nak…
Part Number: TL16C2552 Dear Specialists,
My customer is considering TL16C2552 and has questions.
I would be grateful if you could advise.
---
I have a question about TL16C2552.
① When using the MF pin as OP by AFR, When INT-Enable is enabled by the 3rd…
Part Number: TL16C2552 Dear Sir or Madam,
Uses TL16C2552FN as an alternative to PC16552DV / NOPB. I tried to replace it, but it does not work (UART communication). The MCR Register settings are BIT3 (1) and BIT5 (0). What kind of confirmation is required…