Search tips
Showing 66 results View by: Thread Post Sort by

  • TL16C754C: Problem replacing ST16654 with TL16C754C - Data hanging

    Part Number: TL16C754C Other Parts Discussed in Thread: AM3352 Hello, INTRODUCTION: My name is Everett Sykes. I'm a design engineer for Western Telematic, Inc. in Irvine CA. I’m using a custom board based on the Beaglebone Black with an AM3352 processor…

  • TL16C754C: External clock frequency supported by TL16C754C IC

    TI Thinks Resolved
    Part Number: TL16C754C Tool/software: Hi Team, We are using the quad UART IC (TL16CP754CIPMR). We wanted to know if an external clock of 7.327 MHz frequency will be supported on this IC. If so, can we get a list of the divisor values, to get 16x…
    • Answered

  • TL16C754C: Development Board for TL16C754C

    Resolved
    Part Number: TL16C754C Tool/software: Hi, I am planning to develop a system where I need at least 4 channel UART interface. I would like to know if there is any development board for TL16C754C/ TL16CP754C. If there is any active product from other family…
    • Resolved

  • TL16C754C: Necessity of pull-up resistors in crystal clock circuits

    Part Number: TL16C754C Due to the EoL of the competitor product and considering the TL16CP754CIPM, but there is one difference. This is because the competitor IC has internal pull-up resistor for crystal circuit, eliminating the need for external 1Mohm…

  • TL16C754C: TL16CP754C

    Part Number: TL16C754C Other Parts Discussed in Thread: TL16C754B , Tool/software: A Quad UART IC (U9), part number TL16CP754CIPM, is being used to send information to two separate ICs (U7 & U11). However, the information being sent to U11 from RXB/TXB…

  • TL16C754C: Interface forum

    TI Thinks Resolved
    Part Number: TL16C754C Tool/software: UART-ICのデータシートについて質問があります:TL16CP754C。 TL16CP754Cデータシートのトップページに「3.3V動作用の32MHz発振器入力クロック(2Mbps)」と記載されています。 これは、動作電圧3.3Vで使用すると、32MHzの発振器入力で最大2Mbpsの通信速度が使用できるということですか? 現在、私は3.3V電源でICを実行しており、24.576MHzの発振器出力はXTAL1ピンに接続されています…

  • TL16C754C: TXB Output Problem

    Part Number: TL16C754C Other Parts Discussed in Thread: TL16C754B , Tool/software: Hello, We recently swapped out TL16C754B with TL16C754C on one of our PCBs. As none of the registers changed between the two, we did not make any changes to the firmware…

  • TL16C754C: Write command format

    Answer Suggested
    Part Number: TL16C754C Tool/software: Hi Expert, Customer find they can read registers, but they can't write register successfully. Now they test the timing, t6s, t6h, t13w, t16s all is higher than 1us. So could you give a write command example based…

  • TL16C754C: Software demo code?

    Part Number: TL16C754C Tool/software: Hi Expert, Does Ti have the software demo code to provide to apply this device better and quickly?
    • Answered

  • TL16C754C: TL16CP754C sporadic Parity Error (PE) only during continuous RX stream — CP part but behavior resembles short-stop workaround

    Resolved
    Part Number: TL16C754C Other Parts Discussed in Thread: TL16C752D , Hi team, We are seeing sporadic parity errors on RX with a TL16CP754C-based board. Because this is the “CP” version (errata-fixed according to TI E2E), we would like to confirm whether…
    • Resolved

Didn't find what you are looking for? Post a new question.