Part Number: TLK1501 Hi all,
We would like to use TLK1501 in 50 ohm environment. Could you please answer the questions given below?
RREF is given as 200 ohm in the datasheet. However, 100 ohm resistor is used in the EVM circuitry. (Please see attached…
Part Number: TLK1501 Hi all,
TLK1501 does not work with the value of 200 ohm in a 50 environment. (when AC coupled mode is chosen.)
We think RREF is directly related to VOD(pp_p). What is the recommend value of VOD(pp_p) for AC coupled mode? Please…
Part Number: TLK1501 Tool/software: Hi, I am providing GTX_CLK, wanting system to work at 31 MHz for reading data only : RX[0:15] I noticed that providing providing sine wave signal at 31MHz on GTX_CLK within the required volt range does the job. I wanted…
Part Number: TLK1501 Tool/software: Hi ti team,
The customer is looking for a video chip to convert the digital video signal output by the FPGA into an HDTV video signal (the signal format can be adjusted according to the requirements of the video chip…
Part Number: TLK1501 Other Parts Discussed in Thread: LMK6C
Tool/software:
Hi, I designed a board using the TLK1501 and an SFP module for communication between two identical boards over fiber. However, I am facing an issue with bidirectional communication…
Part Number: TLK1501
Hello.
Connect TLK1501 and SFF transceiver.
SFF transceiver
The impedance of TX and RX is 100Ω differential.
Impedance control of TLK1501 and SFF transceiver is 100Ω differential.
Is there not a problem?
Thank you.
Part Number: TLK1501 Tool/software: hi TI Expert，
Could you please provide the model of eye mask, that is, the coordinates of the white diamond in the middle of the picture? Used to test product consistency。
可否提供下eye mask 的模型，也就是图片中间白色菱形的坐标，用于测试产…
Part Number: TLK1501 Tool/software: Dears,
We are using TLK1501 to transmit data in between two FPGAs. In the FPGA side we wait for at least 0.4 ms for pll setup, receive idles and than transmit counter values counting up. In the receiving side we see…
Part Number: TLK1501 Hi:
m y board has two tlk1521 and SFP Fiber channels , the frequency is 50MHz,when I test with twist wires with both of tlk1521 are ok(no SFP ), the lock signal is ok , and the RX clock can lock constant the 50MHz clock, and I can…
Part Number: TLK1501 Hi,team,
My customer has the following questions,
"I would like to know the cable length limit (guideline) when using the TLK1501 (0.6-1.5Gbps transceiver) with copper cable. Two patterns when the serial data speed is set to 0…
