Part Number: TLK2501 We're working with a design using a TLK2501 and find it frequently gets in a state where it receives incorrect data. The transmitter has TX_EN high and TX_ER low, and the receiver has RX_DV high and RX_ER low, but the ouput at the…
Part Number: TLK2501 Hi Team,
Attached are the schematic diagram and PCB board. Please help review them In addition, there are the following questions currently, please help answer them: 1. Is there a problem with the TLK2501 running 1080P 60HZ at full…
Part Number: TLK2501
Tool/software:
Hello TI Rep,
We’re observing rare, localized data corruption across multiple systems that use the TLK2501 as the high-speed transmit serializer. In a representative run at room temperature, we captured 10 bad…
Part Number: TLK2501EVM Other Parts Discussed in Thread: TLK2501 Tool/software: Hi Team,
I'm connecting TLK2501EVM to and FPGA with the following DC and AC characteristics:
In the picture above the relevant info is DVPPOUT (800mV) and the common mode…
Part Number: TLK2501EVM Tool/software: Hi,
we have connected the EVM to receive only and we are sampling the data on the RXD/CLK/ER/DV signals (2Gserdes, 100Mhz parallel - GTX_CLK).
the device is syncing (RX_DV/ER deassert) and we are sampling the…
Part Number: TLK2501 Tool/software:
Hello,
I measured an eye width of about 310 ps on the TLK2501 serial receiver pins (see attached file). However the eye has a poor signal quality, really slow rising time.
My questions:
1. The receiver side…
Part Number: TLK2501 Other Parts Discussed in Thread: TLK1501 Tool/software: Hello,
We want to interface the TLK 2501 serial interface to an optical transceiver. Looks like the Netlight 1417K4A is obsolete. Can i use the finisar FTLX8574D3BCL Datasheet…
Part Number: TLK2501 I tried to use a CG635 clock source to drive the GTX_CLK directly, but the measured amplitude of GTX_CLK is much smaller compared to the setting at CG635. Similarly when I use the LVCMOS18 output clock from AD9255
to drive the GTX_CLK…
Part Number: TLK2501 Dear Atul,
is there any verilog simulation model available for TLK2501?
If yes, could you please send me the model?
Thanks a lot
Majid
