Part Number: TLK2501 Hi,
I found the discussion about IBIS model of TLK2501 in this thread, but it's for TLK2500. Can this model be used for TLK2501 also?
Best Regards
Satoshi / Japan Disty
Part Number: TLK2501 Other Parts Discussed in Thread: TLK6002 Hi team,
The customer is looking for the successor device to TLK2501 satisfying with the following requirements.
- 8b/10b - Enough signal integrity between Altera FPGA Cyclon10 via SerDes…
Part Number: TLK2711-SP Other Parts Discussed in Thread: TLK2501 , Dear Team,
Does the TLK2711-SP is compatible with the TLK2501 - meaning can they communicate with one another ?
Can we have TLK2711-SP on one board and TLK2501 on another for data…
Dear TI,
After one month of testing, data transmission with TLK chips is still not possible. I would like to ask a few more questions. My questions are as follows:
Is the TLK chip protocol exactly the same as the PCS and PMA agreement of IEEE802…
Part Number: TLK2501 Dear Team,
My customer is working with the TLK2501 for the past 10 years.
In recent design they have an issue regarding PLL lock signal.
They are connecting pin # 41 – RX_CLK to a MMCM input of ARTIX7 FPGA from XILINX.
From…
Part Number: TLK2501 Other Parts Discussed in Thread: TLK1501 Dear TI-er. My customer want replace TLK2541 to TLK2501. Can it replace ?
1. Device's Speed 1) TLK2541 (Obsolete) : 1G to 2.6G 2) TLK2501 (Active) : 1.5G to 2.5G The current system is the…
Part Number: TLK2501 I am studying the use of TLK2501 SerDes for a laser-base inter-satellite Free Space Optical long haul link (4000 km). The goal is to establish a 500 Mbit/sec to 2 Gbit/sec data link. I have two questions
1 I've seen that TLK2501…
Theresia,
In Case 1, Do you have both SFP module internal AC coupling and external AC coupling? If you have both this may be causing issue with your system where the differential signal amplitude on the serial receive terminals is below 200 mV. Then…
Hi Robert,
You are right. And you actually don't need to connect TX_EN/TX_ER to RX_DV/RX_ER. You can think of it as if they are connected internally. Basically, you can tie TX_EN high and TX _ER low and upon power up/reset, the TLK2501 transmitter…
