Other Parts Discussed in Thread: TLV320AIC10 , TMS320F2812 Hi,
In the Data Manual of TLV320AIC10,Fs = Sampling (conversion) frequency = MCLK/(256 × N), N = 1, 2..., 32。The value of N is defined in control register 2。In my application,MCLK is 2.048MHz,control…
Other Parts Discussed in Thread: TLV320AIC10 Hi,
In our application, F28069 needs to be connected to Codec TLV320AIC10 through McBSP interface. We couldn't find the sample codes with McBSP as Slave. Please let me know if there is a any reference projects…
Hi Team,
I understood "Frequency divider" can be change by accessing Control Register2[4:0].
If I change(access) this register, when does it reflect SCLK frequency?
Could you tell me the max transition time?
Best Regards,
Yaita / Japan dist…
Hi Team,
My customer uses direct configuration mode and asked me about timing requirement for DCSI.
Are "Setup Time(MIN)" and "Hold time(MIN)" for DCSI same as for DIN(following value)?
'I'd like to confirm just in case. …
Hi Team,
My customer would like to know the output impedance of A3/A4(general-purpose opamp).
The datasheet shows output power, however there is no description about output impedance.
Could you tell me the value?
Best Regards,
Yaita / Japan dist…
Other Parts Discussed in Thread: TLV320AIC10 Hello,
Could you teach me VIL and VIO of the digital interface for TLV320AIC10. I can't find from the datasheet.
Best Regards.
Nomoto
Other Parts Discussed in Thread: LM4951 , TLV320AIC10 , TLV2374 , LM2575 , LM386 Hi,
I am using TLV320AIC10 as codec to work with AMBE2000 vocoder. I configured AIC to suit AMBE2000 and tested. Audio is heard at the receiver AIC, but I found some background…
Other Parts Discussed in Thread: TLV320AIC10 , PCM3500 Hi,
I am using TLV320AIC10 with AMBE2000. I here slight motor boating sound during conversation. This noise is not there when I replace TLV320AIC10 with PCM3500. The AMBE configuration and software…
Other Parts Discussed in Thread: TLV320AIC10 Hi,
I have configured TLV320AIC10 to work with SCLK = 2.048MHz, FS = 8kHz. DIN and DOUT pins are connected to AMBE2000 vocoder chip's CODEC_RX and CODEC_TX respectively (as per the AMBE2000 application note…
Hi,
I am trying to configure AIC through DCSI port. DCSI port is connected to BlackFin ADSP533 SPORT. AIC configuration data is clocked out of ADSP533 SPORT serially at SCLK rate. There is inconsistency in the configuration. Has anyone tried configuring…