Part Number: TLV70018-Q1 Tool/software: We are using TLV70018DDCR which states "The devices regulate to specified accuracy with no output load." A previous designer was told by TI that a minimum load was required for reliability/stability since our actual…
Part Number: TLV70018-Q1 Tool/software: Using the TLV70018 on a board with several other LDO. In the circuit below, C52 is installed with a 10k pulldown. Regardless, when the 3.3V supply appears, the output of U3 rises to about a volt before turning off…
Part Number: TLV70018-Q1 Other Parts Discussed in Thread: TLV70018QDDCRRB Tool/software: We’re using the LDO - TLV70018QDDCRRB in a Gateway CGW project, kindly provide the following info:
Graph characteristics - startup time and discharge time (Voutput…
Part Number: TLV70018-Q1 Other Parts Discussed in Thread: TLV700 anyone run into this, the ti link to buy this part shown above show a picture of either the sot23 or sc70 package, show the part number for the wson6 package and stated that the package…
Part Number: TLV70018-Q1 Hi Team:
Could you help me to check the TLV70018Q1 ESD spec?
For datasheet first page, it show Device HBM ESD Classification Level H2.
But the 6.2 section show the ESD rating is +/-2000V.
And the ESD spec is below: …
Hi Alex,
sorry for the late response.
I tested your model and it works! Thanks a lot for your help!
One further question: Could you also provide such an unencrypted model for the TLV70018 ( TLV70018-Q1 data sheet, product information and support…
Part Number: TDA4VM Other Parts Discussed in Thread: TPS73101-EP , TLV70018-Q1
Hello
I am curious about the difference between configuring the LDO for eFUSE power and using the LDO3 of PMIC-B.
PDN Note (v0.18)
6) SoC devices come in two types…
Hello, E2E support engineer
You mentioned that 850mA is that 3.3V supply for module VBAT directly consumes the maximal current in WLAN.
How can I evaluate the maximal current of 1.8V of VIO for this module?
For my case, I used a LDO(TI TLV70018…
Hello Keerthy,
Thanks for the reply.
I have same VDD_CPU_AVS_REG power source in my custom board as per below link:
e2e.ti.com/.../DRA829_5F00_TDA4VM_5F00_3Ph_5F00_Dual_5F00_Leo2.0_5F00_PDN_2D00_0C_5F00_v0.18.pdf
- Harshil.
