Part Number: TLV741P Is there any rise time limitation for the input voltage to the IN pin?
(In the case of two pattern, EN connect to IN, and EN not connect to IN)
Is there no problem with extremely slow rise time for input voltage?
Best regards…
Part Number: TLV741P Hi,
Based on the datasheet, when EN < 0.4V, device enter into shutdown. When EN>0.9V, the device is enable, how about when user accidently float the EN pin and voltage lies between 0.5V ~ 0.89V?
What state is the device in…
Part Number: TLV741P Hello.
I want to use TLV74133 and have one question about UVLO level. Am I right, that UVLO level is common for different outputs of TLV741 and it is 1.4V? For example, for LDO TLV74133 and for TLV74118 this level is 1.4V? It very…
Part Number: TLV741P Hi team,
Could you help me to find AN34078A TI cross?
https://jp.digchip.com/datasheets/part_details.php
It is basically 3.3V-to-1.8V LDO + bypass switch for SD card power supply.
Does TI have LDO with bypass switch, or any…
Part Number: TLV741P Hi team ，
When LDO is used to supply power to LPDDR4, there is a large start-up overshoot in Vout at the moment when Vin is powered on. The waveform is shown in the figure below, and the amplitude is about 1.9V.
After replacing…
Part Number: TLV741P Hi team,
My customer is considering to use the TLV741P. The d/s recommends minimum 1uF for output capacitor. Could you tell me the minimum effective capacitance required for the output cap?
Regards,
Yamaguchi
Part Number: TLV741P Hello team,
This might be basic question but can we use fig10 for Vin3.3V, Vout2.5V as well?
The customer is a little bit concerned about it.
If there's no big differences between Vout2.5V vs Vout1.8V, I'm going to tell the…
Part Number: TLV741P Hi
Minimum current limit of TLV741P is written 180mA in datasheet.
Could you tell me the maximum current limit of TLV741P?
Best regards,
Yokota
