Search tips
Showing 51 results View by: Thread Post Sort by
    Answered

  • TM4C123BH6PM: The REC and the TEC bit in the CANERR register

    Resolved
    Part Number: TM4C123BH6PM Hi Team, Would you please teach me the reset condition of REC and TEC bit in CANERR register? Is The REC and the TEC bit in CANERR rest by Rx bit in SRCAN? Thanks and Best regards, Kuerbis
    • Resolved

  • TM4C123BH6PM: The timing requirement of reset by Rx bit in SRCAN register for CAN module

    TI Thinks Resolved
    Part Number: TM4C123BH6PM Hi Team, Is there any timing requirement of reset by Rx bit in SRCAN register for CAN module? How long we have to keep reset by Rx bit? Thanks and Best regards, Kuerbis
    • Answered

  • RE: TM4C123BH6PM: Slave mode SSITx Timing spec on MODE3(SPH=1,SPO=1)

    Resolved
    ay0689, Your understanding is correct.
    • Answered

  • CCS/TM4C123BH6PM: Problems with projects properties

    Resolved
    Part Number: TM4C123BH6PM Tool/software: Code Composer Studio Hi everyone! I have been busy on a ti-rtos based project for a while and need to set up CCS on my notebook now. Good step to move from CCS6.1.1 to CCS8.1.0 I thought. Unfortunately when…
    • Resolved

  • TM4C123BH6PM support boot feature?

    Other Parts Discussed in Thread: TM4C123BH6PM Dear team, Please advise if TM4C123BH6PM support the secure boot feature or not? Regards Rajesh
    • Answered

  • RE: CCS/TM4C123BH6PM: Project transfer problems on a custom board

    Resolved
    Hello Simon, Please do make sure that you make the corrections as per the System Design Guidelines for the final board. Otherwise when the device sees to higher activity period the current draw may cause voltage drops.

  • Is the TM4C123BH6PM approved for Class 3 medical use?

    Other Parts Discussed in Thread: TM4C123BH6PM Is the TM4C123BH6PM approved for Class 3 medical use? If not, are any tiva's approved?

  • RE: Problems with TM4C123BH6PM's SSI interface

    Min-Ku Yeo said: using the TM4C123BH6PM with the same source code, sometimes the data from these MEMs sensors give terrible results. Well - that's better than famed, "MCU does not work!" but would be strengthened if you had stated that - at times…
    • Answered

  • RE: PWM Code on TM4C123BH6PM

    Resolved
    Hello Derek and cb1-. I admit too. Using the Tivaware can save a lot of times and effort for developers. However, I just wanted to have some time to make my own functions for my skills. I wanted to understand how the registers work to activate…
    • Answered

  • QEI not working properly(TM4C123BH6PM)

    Resolved
    Other Parts Discussed in Thread: TM4C123BH6PM Hi, I'm using QEI in order to count a rotation of a remote car's wheel. I connected a digital hall sensor output to QEI module 1's input A(PHA1/PC5, capture mode : Only PhA). The hall sensor is WSH131…
    • Resolved

Didn't find what you are looking for? Post a new question.